Garden GP00 Installation And User Manual - Page 12
Browse online or download pdf Installation And User Manual for Water Pump Garden GP00. Garden GP00 16 pages. Swimming pool heat pump
Print Page
２ ２ ２ ２ ． ． ． ． Trial
A． Please start the pump before the heat pump and turn it off after the heat
pump, so there is water running through the system throughout operation
hours.
B．The user should start the pump, making sure the water pressure is correct;
set the desired temperature on the thermostat, and then switch on the power
supply.
C．In order to protect the swimming pool heater, the Heat Pump is equipped
with a time lag starting function, when starting the Heat Pump, the blower
will run 1 minute before the compressor;
D．After the swimming pool heater starts up, check for any abnormal noise
from the Heat Pump.
VIII.
Be Careful
１ １ １ １ . Attention
A. To set the desired temperature in order to get comfortable water temperature;
this will avoid overheating or overcooling;
B. Please don't stack objects that can block air flow near intake or outlet area,
the Heat Pump's efficiency may be reduced or even stopped;
C. Please don't put hands into the outlet of the swimming pool heater, and
don't remove the screen of the fan at any time;
D. If there are suspect conditions such as noise, smell, smoke and electrical
leakage, please switch off the machine immediately and contact the local
dealer. Don't try to repair it yourself;
E. Do not use or stock combustible gas or liquid such as thinners, paint and
fuel near the Heat Pump to avoid fire;
F. In order to optimize the heating effect, please install heat preservation
insulation on pipes between swimming pool and the heater. When the Heat
Pump is working please use a recommended cover on the swimming pool
to avoid heat loss through evaporation;
G . The Heat Pump should be placed ≤10m of the swimming pool, or the