Avanti WDT51 Instruction Manual - Page 7

Browse online or download pdf Instruction Manual for Water Dispenser Avanti WDT51. Avanti WDT51 15 pages.
Also for Avanti WDT51: Instruction Manual (15 pages)

Print Page

•

Fill water tank with tap water full to capacity (almost 3/4 of a gallon). Wait for 5

minutes until water settles.

•

Press the hot water faucet until water comes out, then stop.

•

Plug the dispenser into the electrical outlet. All three indicator lights on front will

light up at first. We are ready to complete the first cycle. In order to do that, wait

for the hot water indicator light to go off first (approximately 10 minutes), then wait

for the cold water indicator light to go off (another 5 minutes, approximately).

•

Unplug the dispenser from the electrical outlet. Proceed to drain the water from

the faucets one at a time until no more water remains.

(Note: To facilitate this operation, use a large container).

•

Then, drain any water left in the tanks by opening the drain caps located on the

back, one at a time. First the one marked "hot" until it drains completely. Then the

one marked "cold".

•

Proceed to close both drain caps. Also make sure both faucets are in the off

position.

•

Place the 5 gallon bottle of water on the water intake, allow water to stand for

approximately one minute.

•

Turn on water faucets to insure water flows from both faucets.

•

Plug dispenser into the electrical outlet.

•

Now you are ready to use your water dispenser.

NOTE: Your water dispenser has been cleaned and sanitized before leaving the

factory, but in case a taste problem develops, place one tablespoon of

baking soda and add tap water. Fill water tank again and repeat basic

operations previously outlined, except turn the switch market hot "OFF" to

avoid leaving residues in hot water tank.

ATTENTION:

If you do not plan to use the water heating function for more than three days, we

recommend that you turn the hot water switch to "OFF" position.

IMPROPER USE OF THE GROUNDED PLUG CAN RESULT IN THE RISK OF ELECTRICAL SHOCK. IF

THE POWER CORD IS DAMAGED, HAVE IT REPLACED BY AN AUTHORIZED AVANTI PRODUCTS

SERVICE CENTER.

Steps to replace water bottles

Use a clean cloth to wipe off neck of bottle.

Remove cap.

Carefully lift bottle (approx. 40 lbs.) using your legs and not your back. Do not place hands in

opening of bottle while placing in reservoir.

Insert the water bottle on the water intake over reservoir opening so it settles properly on it.

Wipe off any water which may have splashed on dispenser top.

Cold Water Control

Turn the cold-water switch (12) on. The green indicator will be lit and the process begins. When the

water reaches the right temperature the green light goes off automatically.

Hot Water Control

Turn hot water switch (13) on, the red indicator will be lit and the unit will begin to heat the water.

When the water reaches the right temperature the red light goes off automatically.

WARNING

OPERATING YOUR WATER DISPENSER

When the