Garden Lights FOCUS Plus SMART 3200011 User Manual - Page 7

Browse online or download pdf User Manual for Outdoor Light Garden Lights FOCUS Plus SMART 3200011. Garden Lights FOCUS Plus SMART 3200011 12 pages.

Print Page

The Garden Lights Focus Plus is a smart light, for

use in combination with the Garden Lights 12-volt

outdoor lighting. To operate the smart lights, the (free)

Garden Lights app should be installed on a suitable

smartphone or tablet. For more information on how to

download and use the app, go to

www.garden-lights.com/en/smart.

[!] Make sure all parts are included in the packaging.

You can always contact us with any questions you may

have about parts or service, as well as complaints or

other matters. Email: [email protected].

Use

When installing the Focus Plus, keep in mind the

following regulations:

1 The Focus Plus must be connected to a 12-volt

Garden Lights system with a permanent voltage

supply.

2 The Focus Plus cannot be used in combination with

the following accessories:

• Motion Sensor (art.nr. 6156011)

• Receiver (art.nr. 6148011 and 6149011)

3 When placing the smart lamps, consider the

distance to the smartphone. The lamps have a

good connection up to 16 meters. If the distance

increases, the signal slows down.

4 The smart lights amplify the Bluetooth signal to

each other. For proper operation, place the light up

to a maximum distance of 20 meters from each

other.

5 The Focus Plus cannot be placed behind a

Switch Plus (art.nr. 6269011) because it must be

continuously supplied

with power.

Restore factory settings

In the event of a malfunction, or if you have forgotten

your password (set via the app), the Focus Plus can

be reset to factory settings. To do this, proceed as

follows:

[!] Warning: This will reset all Garden Lights Plus lights

in your system to factory settings. Disconnect any

lights whose settings you want to keep from the main

cable before starting!

1 Make sure the system is supplied with power.

2 Leave the lights on for a minimum of 15 to a

maximum of 20 seconds.

3 Disconnect the power from the system (e.g. by

removing the plug of the lamp from the cable).

4 Wait a minimum of 5 to a maximum of 10 seconds.

5 Reconnect the system (plug the transformer back

into the power outlet).

6 Repeat steps (2) to (5) several times.

7 When steps (2) to (5) have been correctly followed

three times in a row, the Garden Lights Plus lights

will flash red several times.

8 Wait until the lights stop blinking and light up white.

The factory settings have now been restored and

the lights are ready for use again.

SMART