GARDEN MASTER GM3023 Assembly Instructions Manual - Page 2
Browse online or download pdf Assembly Instructions Manual for Outdoor Storage GARDEN MASTER GM3023. GARDEN MASTER GM3023 8 pages. Gable roof shed
Also for GARDEN MASTER GM3023: Assembly Instructions (2 pages)
Print Page
ASSEMBLY OVERVIEW
These instructions are designed to guide you though the process
of building your new garden shed. It is a simple process of joining
sheets together before adding top and bottom channels to form a
shed panel. These panels are then joined together to make your shed.
When fitting the channels to the sheets, the high side of the channel should go on the inside of the sheet, ensuring that
any water that collects in the bottom channel will run over the lower side and run away rather than into the shed.
Rivets are fitted by drilling through outside of the channel into the ribs of the sheet, usually at every second rib. It is
also important to fit at least one rivet per sheet from the inside of
the channel into the pan of the sheet, close to a rib. Extra rivets
should be fitted on the inside of the channel into the pan of the
sheets in high wind areas.
It is critical that you remove the swarf (the metal filings created
when drilling) from the panels and channels as you assemble
them as these will rust quickly and could cause corrosion issues
with your shed!
COMPONENTS CHECKLIST
Please check the parts carefully and advise immediately if any are damaged or missing.
4 x 1830mm sheets for back
A
1 x 1830mm sheets for front
Door pre-hinged to 740mm
E
sheet with door jamb
4 x 1200mm 'L's for flashing
I
the roof to the side walls
1 x pack of rivets, 1 x riveter, 1 x drill bit. and a padbolt pack with wide
M
flanged rivets for fixing the padbolt on to the door and door jamb.
If you need advice, call us
2
If you choose to vary from these instructions your warranty will be impaired.
8 x 1200mm sheets for roof
B
4 x 3000mm channels
F
with ends cut for front and
back walls
2 x 793mm door spacers
J
FREE
on
0800 807 433
or email us at [email protected]
INSIDE
OUTSIDE
4 x sloping sheets &
C
2 x gable cut sheets for the
centre of the end walls
4 x 3000mm channels
G
for roof
1 x 3025mm ridge beam
K
1 x 2975mm roof support slat
2 x 'Z' door braces
N
RIB
PAN
1 x 740mm wide sheet with
D
door jamb attached
2 x 2255mm channels for
H
bottom & 2 x 2290mm
channels for top of end walls
2 x small gable plates
L
for the outer & 2 x small
for the inner.
Wooden block