Jands Vista S3 Setup Manual - Page 4

Browse online or download pdf Setup Manual for DJ Equipment Jands Vista S3. Jands Vista S3 8 pages. Usb consoles
Also for Jands Vista S3: Setup Manual (8 pages)

Print Page
Jands Vista S3 Setup Manual
Connections
DMX
USB to host
USB outputs
LTC
(S1 and S3
only)
MIDI
(S1 and S3
only)
Desklamp
About the Vista dongle
The dongle is a USB device that the Vista software requires to enable
output through either the computer's Ethernet connection or the console's
DMX outputs. Vista T4 and T2 products are factory fitted with a dongle,
while an E2 does not require one.
Normally your supplier will fit the dongle to the USB Console when you
buy it, but if it hasn't been fitted you can either:
•
•
Jands USB Console Setup Guide Version 1.0
Two or four DMX outputs are available from the USB
Console, depending upon the model. The actual number
of DMX channels available to you will depend on the
type of dongle you have purchased (e.g. 128, 512, 2048,
etc)
One Type B
Type A, quantity depends on the USB Console
You can use SMPTE Timecode as a trigger input.
Information on using timecode is included in the Vista
software manual
Standard MIDI IN, OUT and THRU connectors are
available, but MIDI is not currently implemented in the
Vista software
Connect a standard gooseneck desklamp (not supplied)
plug the dongle into any available USB port on the computer or the
rear panel of the console, or
have your dealer fit the dongle to the internal USB port on the USB
Console (S3 and S1 only). If you choose this option we recommend that
you get it done by a qualified service person. If you are qualified to do
this yourself, contact Jands for a technical note.