Avaris Odysey Owner's Manual - Page 11
Browse online or download pdf Owner's Manual for Bicycle Avaris Odysey. Avaris Odysey 17 pages.
Print PageAttach & Adjust the Handlebar:
Your handlebars have two main parts, the bar itself and the stem. If your bar has been removed for shipping,
position the bar in the centre of the stem and check to be sure that your grips are in the right place, and that the
angle of the bar is comfortable, whilst also enabling you to shift gears and apply the brakes accordingly. Tighten the
stem clamp bolts to hold the handlebar in the desired setting. Apply an even torque load to each of the clamp bolts.
DO NOT over tighten. Ensure that all cables are clear and out of the way.
SECTION FOUR:
Power Assistant System:
This is a power assisted bicycle. It equips a 1:1 speed type power assistant transducer, to control the rotation
of the power system. (Fig. 6).
The following statement: The A-weighted emission sound pressure level at the driver ears is less than 70
dB(A)
Battery Pack:
The electric bicycle is equipped with a Li-ion battery pack. (Li-ion 36V/20Ah) for a 29" MTB bike.
The battery can be used at temperatures between -20 degrees and 50 degrees
Battery storage is between 20 and 25 degrees
Battery Charger:
When charging, the battery charger and the battery should be set at least 10 centimetres away from its charging
point. When wanting to charge the battery, please follow these steps accordingly:
1. Connect the charger cable output plug into battery input socket.
2. Connect the charger cable input plug into the electrical output supply socket.
3. Turn on the charger power switch to charge the battery, the red light should come on.
4. When the red light turns to green, the battery is fully charged.
5. Turn off the charger power switch and unplug the cable.
WARNING: Please ONLY use the original battery charger for charging of the battery. Failure to do this will result in
damage to the battery, affecting overall battery service life.
Power On Display:
When the battery power level goes below 50%, be sure to place the battery on charge asap. Never let the
battery deplete to 0%, otherwise the service life of the battery will be affected, because it has over discharged.
INTRODUCTION TO COMPONENTS
Fig. 6