Lexmark 945e - X Color Laser Troubleshooting Manual - Page 10
Browse online or download pdf Troubleshooting Manual for Printer Lexmark 945e - X Color Laser. Lexmark 945e - X Color Laser 14 pages. Setup sheet
Also for Lexmark 945e - X Color Laser: Clearing Jams Manual (8 pages), Fax Manual (3 pages), E-Mail Manual (3 pages), Ftp Manual (2 pages), Accessory Installation Manual (2 pages), Setup Sheet (1 pages)
Print Page
D
O MARKS OCCUR REPEATEDLY ONLY IN ONE COLOR
?
AND MULTIPLE TIMES ON A PAGE
Replace the photoconductor(s) if the defects occur every:
•
44 mm (1.7 in.)
•
94 mm (3.7 in.)
Note: The printer has four photoconductors: cyan, magenta,
yellow, and black. The cyan, magenta, and yellow
photoconductors must all be replaced at the same time. The
black photoconductor can be replaced separately.
Skewed print
C
HECK THE PAPER GUIDES
Move the guides in the tray to the correct positions for the
paper size loaded.
C
HECK THE PAPER
Make sure you are using paper that meets the printer
specifications.
Print is too light
These are possible solutions. Try one or more of the following:
C
,
,
HECK THE DARKNESS
BRIGHTNESS
SETTINGS
The Toner Darkness setting is too dark, the RGB Brightness
setting is too dark, or the RGB Contrast setting is too high.
•
From Print Properties, change these settings.
Note: This solution applies to Windows users only.
•
From the Quality menu, change these settings.
H
AS THE PAPER ABSORBED MOISTURE DUE TO HIGH
?
HUMIDITY
•
Load paper from a fresh package.
•
Store paper in its original wrapper until you use it.
C
HECK THE PAPER
Avoid textured paper with rough finishes.
C
P
T
HECK THE
APER
YPE SETTING
Make sure the Paper Type setting matches the paper loaded in
the tray.
M
C
S
AKE SURE
OLOR
AVER IS SET TO
Color Saver may be set to On.
I
?
S THE TONER LOW
When 88 <color> toner low appears order a new
cartridge.
A
TONER CARTRIDGE MAY BE DEFECTIVE
Replace the toner cartridge.
10
Print is too dark
AND CONTRAST
C
HECK THE DARKNESS
SETTINGS
The Toner Darkness setting is too dark, the RGB Brightness
setting is too dark, or the RGB Contrast setting is too high.
•
From Print Properties, change these settings.
Note: This solution applies to Windows users only.
•
From the Quality menu, change these settings.
I
S THE TONER CARTRIDGE DEFECTIVE
O
Replace the toner cartridge.
FF
Solid color pages
The printer may need to be serviced. For more information,
contact Customer Support.
,
,
BRIGHTNESS
AND CONTRAST
?