Jandy AquaLink RS Installation Manual - Page 2

Browse online or download pdf Installation Manual for Control Panel Jandy AquaLink RS. Jandy AquaLink RS 4 pages. Battery wireless, portable control panel
Also for Jandy AquaLink RS: Installation Manual (8 pages), Installation Instructions (1 pages), Installation Instructions (1 pages)

Print Page

3.9. Wireless OneTouch Control Panel-

Installation Considerations- The transceivers will transmit through walls and around corners.

Steel framing, aluminum siding, wrought iron, cyclone fences, lead ed glass may , microwave

ovens, and other 2.4 GHz frequency items may inhibit/prevent com mu ni ca tion between the

Wireless AquaL ink RS Control Panel and the Power Center. The trans ceiv ers do not require

line of sight to communicate. To optimize communication, locate trans ceiv ers to minimize

interference. The Battery Wireless AquaLink RS system requires OneTouch Indoor PCB

revision "E" and ﬁ rmware revision "B11" in order to work properly.

3.9.1.

Outdoor Transceiver J-box Installation:

1. Turn off all power to the Power Center.

2. Mount the Outdoor Transceiver J-box at least 5' above the ground and at least 8'

from an air blower.

3. Remove the cover from the Transceiver J-box. Use the template provided to drill

the mounting holes. Mount the Transceiver J-box and replace the cover.

4. Open the door to the Power Center and remove the dead panel.

5. Feed the four conductor wire into the Power Center through the low volt age

raceway.

6. Cut off the excess wire. Strip the jacket back 6" and strip the individual wires

approximately ¼". Connect the four conductor wire to the red terminal bar on the

Power Center PCB.

7. Install the dead panel to the Power Center and restore all power.

3.9.2.

Indoor Control Panel Installation:

1. Connect the transformer to the back of the control panel.

2. Plug the transformer into a wall socket.

3. Charge for 24 hours before removing the Power Supply/Charger (the

system is operational while charging).

J-box Trans-

ceiv er

Ground

Level

Installation

Minimum 8'

Power

Center

Low Voltage Raceway

Power Supply/

Charger Cord

Air

Blower

Jandy

AquaLink

Red 4-Pin

Terminal Bar

When not in use, turn

the ON/OFF Switch to

the off position.