KitchenAid KEBU107SSS00 Installation Instructions Manual - Page 5
Browse online or download pdf Installation Instructions Manual for Oven KitchenAid KEBU107SSS00. KitchenAid KEBU107SSS00 20 pages. 30" (76.2 cm) electricsingle and double built-in oven
Also for KitchenAid KEBU107SSS00: Parts Manual (7 pages)
Acopyoftheabove c ode standards canbeobtained from:
•
National Fire Protection Association
One Batterymarch
Park
Quincy, MA02269
CSA International
•
8501 East P leasant Valley R oad
•
Cleveland, OH 44131-5575
Electrical
Connection
To properly install your oven, you must determine the type of
electrical connection you will be using and follow the instructions
•
provided for it here.
•
Oven must be connected to the proper electrical voltage and
•
frequency as specified on the model/serial
number rating
plate. The model/serial
number rating plate is located at the
•
bottom of the right-hand mounting rail. See the following
illustration.
Models rated from 7.3 to 9.6 kW at 240 volts (5.5 to 7.2 kW
at 208 volts) require a separate 50-amp circuit. Models rated
at 7.2 kW and below at 240 volts (5.4 kW and below at
208 volts) require a separate 30-amp circuit.
A circuit breaker is recommended.
Connect directly to the circuit breaker box (or fused
disconnect) through flexible, armored or nonmetallic
sheathed, copper cable (with grounding wire). See "Make
Electrical Connection"
section.
Flexible conduit from the oven should be connected directly
to the junction box.
Do not cut the conduit. The length of conduit provided is for
serviceability
of the oven.
A UL listed or CSA approved conduit connector must be
provided.
If the house has aluminum wiring follow the procedure below:
1. Connect a section of solid copper wire to the pigtail
leads.
2. Connect the aluminum wiring to the added section of
copper wire using special connectors and/or tools
designed and UL listed for joining copper to aluminum.
Follow the electrical connector manufacturer's
recommended
procedure. Aluminum/copper
connection must conform with
local codes and industry accepted wiring practices.
Single Oven
Double Oven
A. Model/serial number plate
A. Model/serial number plate
INSTALLATION INSTRUCTIONS
1. Decide on the final location for the oven. Avoid drilling into or
severing existing wiring during installation.
Excessive Weight Hazard
Use two or more people to move and install oven.
Failure to do so can result in back or other injury.
2. To avoid floor damage, set the oven onto cardboard prior to
installation. Do not use handle or any portion of the front
frame for lifting.
3. Remove the shipping materials and tape from the oven.
4. Remove the hardware package from inside the bag
containing literature.
5. Remove and set aside racks and other parts from inside the
oven.
6. Move oven and cardboard close to the oven's final location.
_,_ <;_; _J_,,_©_
IMPORTANT: Use both hands to remove oven door(s).
1. Open the oven door.
2. Locate the oven door latches in both corners of the oven
door, and rotate the latches forward to the unlocked position.
A. Oven door latch in locked
position
B. Oven door latch in unlocked
position