Gardena PowerMax Li-37 Operator's Manual - Page 10
Browse online or download pdf Operator's Manual for Lawn Mower Gardena PowerMax Li-37. Gardena PowerMax Li-37 19 pages. Battery lawnmower
Print Page
To replace the blade:
Problem
Mower does not start
Engine is jammed and
makes a noise
Loud noises, the mower
is rattling
Mower runs unevenly or
vibrates strongly
Mower runs unevenly or
vibrates strongly
Lawn is not cleanly mowed
ç
Error-LED
on the control
panel flashes
ß
Wp
DANGER! Risk of injury!
Cut injury when the blade turns and it is damaged,
bent, out of balance or has chipped edges.
v Do not use the mower when the blade is damaged, bent,
out of balance or has chipped edges.
v Do not regrind the blade.
The GARDENA spare parts are available from your GARDENA dealer
or from the GARDENA service.
Only use an original GARDENA blade:
• GARDENA replacement blade Art. 4103.
v Let the blade replace by the GARDENA Service or a specialist
dealer authorised by GARDENA.
Possible Cause
Battery is not put completely into
the battery holder.
On LED is off.
Safety key is not in positon 1.
Blade is blocked.
Blade is blocked.
Cutting height is too low.
Screws on engine, its fixing or
on the mower housing are loose.
Blade is damaged / worn or the
blade mounting is released.
Blade is very dirty.
Blade is blunt or damaged.
Cutting height is too low.
Over current, engine is blocked.
Over temperature.
Remedy
v Put the battery completely into
the battery holder until it audibly
engages.
v Push the On/Off button.
v Turn the safety key to
position 1.
v Remove the obstacle.
v Remove the obstacle.
v Raise the cutting height.
v Let the screws be tightened by
an authorised specialist dealer
or the GARDENA Service.
v Let the blade be tightened
or replaced by an authorised
specialist dealer or the
GARDENA Service.
v Clean the mower (see
4. MAINTENANCE). If this does
not rectify the problem, contact
the GARDENA Service.
v Let the blade be replaced by
the GARDENA Service.
v Raise the cutting height.
v Remove the battery and remove
the obstacle.
v Let the product cool down.
23