Gardena 1792 Operating Instructions Manual - Page 5
Browse online or download pdf Operating Instructions Manual for Water Pump Gardena 1792. Gardena 1792 10 pages. Dirty water pump
Print Page
Connecting the hose :
4. Operation
Automatic operation :
1
3
14
The universal fitting
in the previous table.
1. Cut off nipples of the universal fitting
to match the hose connection.
2. Screw the universal fitting
3. Connect the hose to the universal fitting
We recommend that you secure 38 mm (1 1/ 2 ") and 25 mm (1")
hoses additionally with a GARDENA Hose Clip Art. No. 1591.
7
Only for 13 mm (1/ 2") hose :
The universal fitting
Regulator Valve Art. No. 977 so that the contents of the out-
let line do not flow back through the pump after pumping. The
Regulator Valve can be ordered from your GARDENA dealer.
To ensure that the pump draws the water out, the water to be
drained must be at least 10 cm deep.
The float switch
water level exceeds the cut-in height and the water is pumped out.
The float switch
2
level falls below the cut-out height.
1. Stand the pump on a firm surface
– or –
use a rope attached through the bore hole in the carrying
2
handle
During automatic operation, ensure that the float switch
can move freely.
2. Plug the power cable
Adjusting the Cut-in and Cut-out Height :
The maximum cut-in height and minimum cut-out height (see
8. Technical Data) can be adjusted.
v Push the cable of the float switch
5
Do not select a cable length that is too long or short to ensure
that the float switch can turn on and off properly.
• The higher the opening of the float switch lock
the cut-in and cut-out height.
• The shorter the length of cable between the float switch
and the float switch lock
higher the cut-out height.
The cable length between the float switch
3
lock
must always be at least 10 cm.
7
allows you to connect all the hoses listed
7
onto the pump.
7
can also be equipped with a GARDENA
5
turns the pump on automatically when the
5
turns the pump off again as soon as the water
to immerse the pump in a well or shaft.
1
into a mains socket.
3
, the lower the cut-in height and the
7
, which are not needed,
7
.
5
into the float switch lock
3
, the higher
5
5
and the float switch
5
3
.