Gardena 6000 1777 Operation Instructions Manual - Page 5
Browse online or download pdf Operation Instructions Manual for Water Pump Gardena 6000 1777. Gardena 6000 1777 14 pages. Submersible pump/dirty water pump
Connecting the hose:
4. Operation
Automatic operation:
5
4
6
3
The universal fitting
table above.
1. Screw L-piece
2. Cut off nipples of the universal
to match the hose connection.
3. Screw the universal fitting
1
4. Connect the hose to the universal fitting
We recommend that 38 mm (1 1/2")- and 25 mm (1") hoses
should be fastened with an additional GARDENA hose clamp
Art. No. 7193.
2
Only for 13 mm (1/2") hose:
The universal fitting
Regulator Valve Art. No. 977 so that the contents of the out-
let line do not flow back through the pump after pumping. The
Regulator Valve can be ordered from your GARDENA dealer.
The float switch
level exceeds the cut-in height and the water is pumped out.
The float switch
level falls below the cut-out height.
1. Stand the pump on a firm surface
– or –
use a rope attached through the bore hole in the carrying
handle
During automatic operation, ensure that the float switch
move freely.
2. Plug the power cable
Adjusting the Cutin and Cutout Height:
(Minimum depth for switching on and off, see 8. Technical Data.)
v Push the cable of the float switch
Do not select a cable length that is too long or short to ensure
that the float switch can turn on and off properly.
The cable length between the float switch
6
lock
must always be at least 10 cm.
• The shorter the length of cable between the float switch
the float switch lock
the cut-out height.
1
llows connection of all the hoses listed in the
2
into the pump.
1
onto the pump.
1
can also be equipped with a GARDENA
3
turns the pump on automatically when the water
3
turns the pump off again as soon as the water
4
to immerse the pump in a well or shaft.
5
into a mains socket.
6
, the lower the cut-in height and the higher
1
fitting which are not needed,
1
.
3
into the float switch lock
3
and the float switch
3
can
6
.
3
and
13