Gardena 8500 aquasensor Operating Instructions Manual - Page 7

Browse online or download pdf Operating Instructions Manual for Water Pump Gardena 8500 aquasensor. Gardena 8500 aquasensor 14 pages. Submersible pump/dirty water pump
Also for Gardena 8500 aquasensor: Operator's Manual (14 pages), Operator's Manual (14 pages), Operating Instructions Manual (14 pages), Operating Instructions Manual (14 pages), Operating Instructions Manual (13 pages), Operating Instructions Manual (14 pages), Operator's Manual (14 pages), Operating Instructions Manual (14 pages), Operating Instructions Manual (15 pages), Operating Instructions Manual (11 pages)

Print Page
Gardena 8500 aquasensor Operating Instructions Manual

6. Maintenance

Flushing the Pump :
Cleaning the suction
base and impeller :
8
9
6
9
6
7. Troubleshooting
Problem
Pump is running,
but doesn't deliver
Pump doesn't start or
suddenly stops during
operation
16
The pumps are virtually maintenance-free.
After having pumped chlorinated swimming pool water or other
liquids leaving residues, the pump should be rinsed with clear
water.
A
V Disconnect the pump from the mains before
1. Only for Submersible Pump 7000 : Unscrew the Phillips
screw
6
base
2. Unscrew the 6 Phillips screws
Phillips screws)and pull the suction base
3. Clean suction base
0 A
4. Reinstall the suction base
5. Only for Submersible Pump 7000 : Insert the suction base
0
cover
screw
8
Note for Submersible Pump 7000:
It is often sufficient to simply remove the suction base cover
and clean the suction base cover
For safety reasons a damaged impeller
exchanged by the GARDENA Service Centre.
Probable cause
Air cannot escape, since
pressure line is closed.
Air locks in the suction base.
Impeller clogged.
When starting the pump,
water height falls below the
min. water level.
Thermal overload switch has
switched the pump off due
to overheating.
Warning ! Electric shock !
Risk of injury due to electric shock.
cleaning the suction base and impeller.
A
and pull the suction base cover
.
6
and impeller
6
into the suction base
A
.
0
off the suction
8
(Dirty Water Pump 7500: 4
6
off the pump.
9
.
and screw in the Phillips screws
6
and screw in the Phillips
0
and suction base
9
can only be
Remedy
v Open pressure line
(e.g. kinked pressure pipe).
v Wait for max. 60 seconds
until the pump deaerates
automatically over the vent
valve. If necessary, switch
off and start it again.
v Disconnect plug and clean
impeller (see 6. Maintenance).
v Submerge pump deeper.
v Disconnect plug and clean
impeller (see 6. Maintenance).
Observe max. media
temperature of 35 °C.
8
.
0
6
.