KitchenAid 30" Installation Instruction - Page 4

Browse online or download pdf Installation Instruction for Ventilation Hood KitchenAid 30". KitchenAid 30" 8 pages.

Print Page

Begin the

imtallation

Remove racks and all other contents from oven

before moving appliance. Be

sure

to remove

all

packaging material (cardboard, protective film,

etc.) from range before use.

A. Remove shipping skid

Remove the 4 cardboard

pads from shipping

box.

Place them on floor as shown to protect appliance's

finish. Rest appliance

(on its back) on pads.

Remove the two 3/8" shipping bolts from wooden

skid. Discard the skid.

B. Extend leveling legs

Once skid is removed, 4 leveling legs are exposed at

bottom of frame.

Loosen legs by applying an adjustable

wrench to the

1%" base of the leveling legs. Back each of them out

about 4 complete turns.

Stand appliance

on its base.

Begin electrical

connection

Grounding Instructions

WARNING:

THIS APPLIANCE

MUST BE CONNECTED

TO A

GROUNDED,

METALLIC,

PERMANENT

WIRING

SYSTEM, OR AN EQUIPMENT

GROUNDING

CONDUCTOR

SHOULD BE RUN WITH THE

CIRCUIT CONDUCTORS

AND CONNECTED

THE EQUIPMENT

GROUNDING

TERMINAL

LEAD ON THE APPLIANCE.

WARNING:

To prevent electrical shock hazard, disconnect

power at fuse box or circuit breaker before

connecting flexible armored cable for

permanent wiring.

A. Remove tetminaf

block cover

W' brass nuts

Retaining

screws

Terminal block is located on back of the appliance

near the bottom.

Remove retaining screws to expose electrical

terminal

block.

USE ONLY the supplied 3/~" brass nuts when

connecting

cord.

USE ONLY ring type terminals to connect cord.