KitchenAid KHLU162MSS0 Installation Instructions And Use And Care Manual - Page 6
Browse online or download pdf Installation Instructions And Use And Care Manual for Ventilation Hood KitchenAid KHLU162MSS0. KitchenAid KHLU162MSS0 20 pages. 36" (91.4 cm) and 48" (121.9 cm) hood liner
Also for KitchenAid KHLU162MSS0: Parts Manual (2 pages)
Print Page
Use and Care Information
WARNING — TO REDUCE THE
RISK OF FIRE, ELECTRIC
SHOCK, OR INJURY TO
PERSONS, OBSERVE THE
FOLLOWING:
Use this unit only in the manner
intended by the manufacturer. If
you have questions, contact the
manufacturer. Before servicing
or cleaning unit, switch power
off at service panel and lock
switch power off at service
panel and lock service panel to
prevent power from being
switched on accidentally. When
the service disconnecting means
cannot be locked, securely
fasten a prominent warning
device such as a tag to the
service panel.
CAUTION: For general
ventilating use only. Do not use
to exhaust hazardous or
explosive materials and vapors.
Replacing the Halogen
lamps:
The hood liner uses 12-volt, 20
watt halogen lamp bulbs.
Before you begin, make sure that
the range hood is turned off and
that the lamps have had sufficient
time to cool.
To replace a halogen lamp:
• Remove 2 screws from the
circular metal trim around the
lamp assembly.
• Pull the trim with the lamp
assembly attached down far
enough so that the lamp can be
pushed out of the socket clips.
• Insert the new lamp into the
socket clips and push the lamp
and trim assembly back up into
the hood.
• Replace the screws.
6
WARNING — TO REDUCE THE
RISK OF A RANGE TOP GREASE
FIRE:
Never leave surface units
unattended at high settings.
Boilovers cause smoking and
greasy spillovers that may ignite.
Heat oils slowly on low or
medium settings.
Always turn hood ON when
cooking at high heat or when
cooking flaming foods.
Clean ventilating fans frequently.
Grease should not be allowed to
accumulate on fan or filter.
Use proper pan size. Always use
cookware appropriate for the size
of the surface element.
WARNING — TO REDUCE THE
RISK OF INJURY TO PERSONS IN
THE EVENT OF A RANGE TOP
GREASE FIRE, OBSERVE THE
FOLLOWING:
Operation
The hood liner is designed to
remove smoke, cooking vapors
and odors from the cooktop area.
For best results, start the hood
before cooking and allow it to
operate several minutes after the
cooking is complete to clear all
smoke and odors from cooking
area.
blower motor
light
switch
switch
Operating the lights:
ON: Move the light switch to the
"1" position.
OFF: Move the light switch to the
"0" position.
Operating the exterior
blower motor:
ON: Move the blower motor
switch to the "1" position. The
SMOTHER FLAMES with a close-
fitting lid, cookie sheet, or metal
tray, then turn off the burner. BE
CAREFUL TO PREVENT BURNS. If
the flames do not go out
immediately, EVACUATE AND
CALL THE FIRE DEPARTMENT.
NEVER PICK UP A FLAMING PAN
— You may be burned.
DO NOT USE WATER, including
wet dishcloths or towels — a
violent steam explosion will
result. Use an extinguisher
ONLY if:
You know you have a Class ABC
extinguisher, and you already
know how to operate it.
The fire is small and contained in
the area where it is started.
The fire department is being
called.
You can fight the fire with your
back to an exit.
blower will begin operating at the
speed set on the speed switch.
OFF: Move the blower switch to
the "0" position.
Adjusting the exterior
blower speed:
Adjusting exterior blower motor
speed:
Move speed control switch to vary
the blower speed from low (at the
left) to high (at the right). The
exterior blower motor will operate
at the speed set when the motor
is turned on.
blower speed
switch