KitchenAid KICU265HWH1 Installation Instructions And Use And Care Manual - Page 3
Browse online or download pdf Installation Instructions And Use And Care Manual for Ventilation Hood KitchenAid KICU265HWH1. KitchenAid KICU265HWH1 13 pages. 36", 48" island canopy range hood
Also for KitchenAid KICU265HWH1: Parts Manual (4 pages)
![KitchenAid KICU265HWH1 Installation Instructions And Use And Care Manual](/uploads/products/server2/2141774/2141774.png)
10 7/8"
71/16 . ......
(27.6
cm)
support
(17.9 cm)
structure
23-5/8"
(80 cm)
overall depth
1" (2.5cm) rain. -
11-1/8"
(23.8 cm) max.
upper
chimney
height
t
23-6/8"
(60 cm)
lower
chimney
height
24-5/8" (62.5 cm) rain. -
34-3/4"
(88.3 cm) max.
overall chimney height
10-1/4"
(26 cm)
canopy height
38" hood 35-3/8"
(89.9 cm) or
_-,_
.... 48" hood 47-1/4"
(120 cm)
overa
w dth
_
upper
chimney
/_f
lower chimney
!
24" (61 cm) rain.
bottom
of canopy
to cooking surface
8" (2.4 m) rain. -
9' (2.7 m) max.
ceiling to floor
Vent system must terminate
to the outside.
Do not terminate
the vent system in an attic or other enclosed
area.
Do not use 4" (10.2 cm) laundry-type
wall caps.
Use metal vent only. Rigid metal vent is recommended.
Do not use
plastic or metal foil vent.
3
36"
(91.4
cm)
base
cabinet
height
For the most efficient and quiet
operation:
• it is recommended that the range hood be vented vertically through
the roof through 9" (22.9 cm) round metal ventwork.
• The size of the vent should be uniform.
• Use no more than three 90° elbows.
• Make sure there is a minimum of 24" (61 cm) of straight vent
between the elbows if more than one elbow is used.
• Do Not install two elbows together.
• The length of vent system and number of elbows should be kept to
a minimum to provide efficient performance.
• The vent system must have a damper. If roof or wall cap has a
damper, Do Not use damper supplied with the range hood.
• Use duct tape to seal all joints in the vent system.
• Use caulking to seal exterior wall or roof opening around the cap.
Determine which venting method is best for your application and
follow "Preparation" under "Installation steps" on Page 5.