Broadata 1100E-TRX Manual - Page 7

Browse online or download pdf Manual for Network Hardware Broadata 1100E-TRX. Broadata 1100E-TRX 18 pages. Fiber optic hd-sdi digital video transport system

Print Page

BCI 1100E User's Manual

Fiber Optic HD-SDI Digital Video Transport System

2.1 Mounting

Before installing the units into your housing, make sure there is

enough space to pull and connect both the electrical and optical

cables without stressing them beyond the manufacturer's

limitations (also known as the bend radius minimum).

2.2 Cabling and Connectors

In order to setup the BCI 1100E properly, make sure to observe

the following instructions when installing the proper cables. The

1100E requires two parts to the cabling setup, the electrical

and the optical. For the optical part, observe the following

procedures, as there are various types of optical connectors as

illustrated on the following page.

2.2.1 Electrical Cable Connection

For the electrical connection, it is required that the following

steps be observed when connecting the video devices, as

they require special attention. They are described in the

following section.

2.2.1.1 HDTV Digital Video Interface

The 1100E's provide one BNC connectors for video input

ports and two BNC connector for video output ports.

Serial Digital Video signal are sent over a 75-ohm coax

cable terminated in a BNC connector (e.g., Belden

1694A or better). The data rate is 1.485 Gbps. Use the

following steps for connecting the video.

Broadata Technical Support, (800) 214-0222