Broadata LBC-H-DRP-Lite Safety Instructions - Page 6

Browse online or download pdf Safety Instructions for Microphone system Broadata LBC-H-DRP-Lite. Broadata LBC-H-DRP-Lite 16 pages. Link bridge hdbaset hdmi transmission system with dropping and repeating video

Print Page

Link Bridge

HDBaseT HDMI Transmission System w/Dropping and Repeating Video

2.2 Receiver Rear Panel

HDMI OUT

1. HDMI OUT and LINK LED: Connect to HDMI display for instant

image display or cascade with another family type transmitter.

The LINK LED will illuminate once the active display signal is

detected.

2. EDID: Switch to A/B to allow device to output image according

to output A/B (A: HDMI, B:CAT OUT) port's EDID. For example,

switch to A and both input and output A is connected to 4K2K's

equivalence signal, both output A and B will obtain 4K2K's signal.

If output B is not connected with 4K2K's display there will be no

image.

3. CAT-5e/6/7 OUT and LINK LED: Connect this port to CAT-5e/

6/7 to HDMI receiver with CAT-5e/6/7 cable along with display

to extend the signal up to 60m. Once the connection is made

with active signal the LINK LED will illuminate.

4. IR IN: Connect with the supplied IR Extender to receive IR

signal from transmitter side and blast out at receiver side. Ensure

that remote controller being used is within the direct line-of-

sight of the IR Extender.

5. IR OUT: Connect with the supplied IR Blaster to blast out the

IR signal received from the receiver side. Place the IR Blastyer

in direct line-of-sight of the equipment to be controlled.

Broadata Technical Support, [email protected]

LINK

EDID

LBC-H-DRP-Lite User Manual

CAT5e/6/7 OUT

IR IN

IR OUT