Gardena ComfortCut Plus 500/27 Operating Instructions Manual - Page 9

Browse online or download pdf Operating Instructions Manual for Trimmer Gardena ComfortCut Plus 500/27. Gardena ComfortCut Plus 500/27 15 pages. Turbotrimmer
Also for Gardena ComfortCut Plus 500/27: Operating Instructions Manual (16 pages), Operating Instructions Manual (16 pages), Operator's Manual (9 pages), Operating Instructions Manual (16 pages)

Print Page
Gardena ComfortCut Plus 500/27 Operating Instructions Manual

7. Troubleshooting

DANGER!
Pulling the filament out
of the filament cassette:
g
h
g
p
h
Problem
The trimmer no longer cuts
Filament cannot be
extended or filament
is consumed rapidly
For any other malfunctions please contact the GARDENA service department.
Repairs must only be carried out by GARDENA service departments or specialist
dealers authorised by GARDENA.
Risk of injury from the cutting filament!
v A lways unplug the mains plug of the Turbotrimmer
before troubleshooting.
If a filament is drawn into the filament cassette you can pull it
out again as described below.
1. Remove the filament cassette
6. Maintenance "Replacing the filament cassette".
2. Press together the plastic ring
between your thumb and forefinger.
3. Draw the plastic ring
cassette (use a screwdriver if necessary).
You can now access the filament that was drawn into the
filament cassette.
4. Unwind the cutting filament
through the eye of the plastic ring
welded filament beforehand using a screwdriver, and unwind
and rewind completely.
h
5. Pull the plastic ring
6. Reinstall the filament cassette
6. Maintenance "Replacing the filament cassette".
Possible Cause
Filament worn or too short.
Filament cassette empty.
Filament drawn into the
cassette or stuck together.
The filament became too dry
and brittle (e. g. over the winter).
Frequent contact between the
filament and hard objects.
g
as described under
h
on the filament cassette
h
over the side part of the filament
p
by approx. 15 cm and thread it
h
. If necessary, loosen the
back over the filament cassette
g
as described under
Remedy
v L engthen the filament
(see 4. Operation "Filament
feed – Tip mechanism").
v R eplace the filament cas sette
(see 6. Maintenance
"Replac ing the filament
cassette" ).
v P ull the filament out of the
filament cassette (see above).
v P lace the filament in water for
approx. 10 hours.
v Avoid contact between the
filament and hard objects.
g
g
.
19