Gardena 1407 Operator's Manual - Page 5
Browse online or download pdf Operator's Manual for Lawn and Garden Equipment Gardena 1407. Gardena 1407 13 pages. Flower box watering set
Also for Gardena 1407: Operating Instructions Manual (12 pages), Operating Instructions Manual (11 pages), Operating Instructions Manual (11 pages), Operating Instructions Manual (12 pages), Operating Instructions Manual (11 pages)
Print Page
To connect the drip heads to the supply pipes
[ Fig. I3 ]:
CAUTION!
The first drip head should be placed directly
above the water surface in the container (see
Fig. O2 / O3). This serves to ventilate the system
and prevents any after-running of the water after
the system has been switched off, especially in the
case of drip heads located below the water level.
(3)
1. Cut off the supply pipe
(5)
point of the drip head
(3)
2. Slide the supply pipe
(5)
the drip head
.
4. OPERATION
DANGER! Risk of injury!
Injury when the product starts accidentally.
v Disconnect the product from the mains before
you fill the container.
Watering programs [ Fig. O1 ]:
The watering programs can be set by the rotary switch
on the watering control. The watering duration is repeated
at the set watering frequency.
Program table
Rotary switch
Watering frequency and Watering duration
position
OFF
No watering
One-time watering for 3 minutes
4 h 6 min
Every 4 hours for 6 minutes
6 h 6 min
Every 6 hours for 6 minutes
8 h 1 min
Every 8 hours for 1 minute
8 h 3 min
Every 8 hours for 3 minutes
8 h 6 min
Every 8 hours for 6 minutes
12 h 1 min
Every 12 hours for 1 minute
12 h 3 min
Every 12 hours for 3 minutes
12 h 6 min
Every 12 hours for 6 minutes
24 h 1 min
Every day for 1 minute
24 h 3 min
Every day for 3 minutes
24 h 6 min
Every day for 6 minutes
48 h 3 min
Every 2nd day for 3 minutes
48 h 6 min
Every 2nd day for 6 minutes
72 h 6 min
Every 3rd day for 6 minutes
To start the watering [ Fig. O1 / O2 / O3 ]:
CAUTION!
Damage to the pump if it runs dry.
v Make sure that the container is always suffi-
ciently filled with water.
12
vertically at the installation
.
fully onto the connection of
3. Slide the other end of the supply pipe
other connection of the drip head
4. Repeat steps 1 to 3 until all drip heads
connected.
5. Slide the end cap
(5)
drip head
.
To assemble the pipe pegs [ Fig. O2 ]:
We recommend the assembly of 3 pipe pegs per 1 m long
flower box.
1. Insert the tube holders
soil of the flower box.
2. Clamp the supply tube
Note:
Art. 1407: A drip head dropper has a flow rate of
approx. 2 litres per hour.
Art. 13158: Each outlet of a drip tube has a flow rate
of approx. 1.6 litres per hour.
(11)
1. Fill the container with the previously calculated amount
of water (make sure that the container in a secure
position).
2. Place the pump in the container filled with water
(make sure that the pump is level with the bottom of
the container).
3. Turn the rotary switch
(3)
fully on the
(5)
.
(5)
are
(9)
onto the free connection of the last
(4)
in the desired positions in the
(3)
into the pipe pegs
Litres per day and drip head /
outlet approx.
Art. 1407
Art. 13158
0.1 litres
0.07 litres
1.2 litres
0.9 litres
0.8 litres
0.6 litres
0.1 litres
0.07 litres
0.3 litres
0.22 litres
0.6 litres
0.45 litres
0.07 litres
0.05 litres
0.2 litres
0.15 litres
0.4 litres
0.3 litres
0.03 litres
0.02 litres
0.1 litres
0.07 litres
0.2 litres
0.15 litres
0.05 litres
0.04 litres
0.1 litres
0.07 litres
0.07 litres
0.05 litres
(11)
to the OFF position.
(4)
.