Fronius KD Supply 2500 Operating Instructions Manual - Page 11
Browse online or download pdf Operating Instructions Manual for Welding System Fronius KD Supply 2500. Fronius KD Supply 2500 20 pages.
Also for Fronius KD Supply 2500: Operating Instructions Manual (16 pages)
Print Page
Connecting the KD Supply 2500 to the cooling unit
and power source
Safety
An electric shock can be fatal.
If the machine is plugged into the mains electricity supply during installation, there is a high
risk of very serious injury and damage. Only carry out work on the machine when
► the mains switch is in the „O" position,
► the machine is unplugged from the mains.
Connecting the
KD Supply 2500
to the cooling unit
and power source
(1)
(1)
(2)
(2)
Risk of short circuit from kinked or damaged cables.
► When positioning the KD Supply 2500, ensure that the cables are not kinked.
10
WARNING!
CAUTION!
Carefully place the KD Supply 2500 on the cooling unit
Turn the power source mains switch to
1
the „O" position
Unplug power source mains plug
2
Remove protective cover from the un-
3
derside of the power source
Firmly press four M5 hexagonal nuts
4
(supplied with the KD Supply 2500)
from the inside into the hexagonal
recesses (1) in the fastening bars
If a cooling unit is present:
Remove the protective cover from the
5
(1)
underside of the KD Supply 2500
(1)
FIrmly press four M5 hexagonal nuts
6
(supplied with cooling unit) from the in-
side into the hexagonal recesses (2) in
the fastening bars
Hold the KD Supply 2500 over the coo-
7
ling unit
Pull the KD Supply 2500 connector as
8
far as possible through the opening on
(2)
the underside of the power source
Establish connection between KD Sup-
(2)
9
ply 2500 and cooling unit
11