Gardena 4000/5 Operating Instructions Manual - Page 5

Browse online or download pdf Operating Instructions Manual for Lawn and Garden Equipment Gardena 4000/5. Gardena 4000/5 13 pages. Garden pump
Also for Gardena 4000/5: Operating Instructions Manual (10 pages), Operating Instructions Manual (17 pages), Operating Instructions Manual (12 pages), Operator's Manual (14 pages), Operator's Manual (11 pages), Operator's Manual (10 pages), Operating Instructions Manual (18 pages), Operator's Manual (10 pages), Operating Instructions Manual (19 pages), Operating Instructions Manual (17 pages)

Print Page

Gardena 4000/5 Operating Instructions Manual

Connect hose to the output side: Note:

4. Operation

Connecting the

Pressure Tank Unit:

Use pressure-tight hoses, such as the GARDENA Premium

Rubber hose of 19 mm (3/4") diameter, Art. no. 4432/8452,

in connection with the GARDENA Quick-Release Threaded

Connector of 33.3 mm (G1) internal thread, Art. no. 7109,

and the GARDENA Suction and High Pressure Connector,

Art. no. 7120, for 19 mm (3/4") hoses and a GARDENA Hose

Clip, Art. no. 7192.

Under no circumstances use these hoses on the suction side.

➔ Connect delivery hose

1. Unscrew the cover

2. Turn the rotary switch

The integrated non-return valve will open.

3. Open the air bleed

4. Open any shut-off devices in the delivery line (watering

accessories, water stop, etc.) so that air can escape before

the priming procedure begins.

5. Empty any water remaining in the delivery hose so that the air

can escape during filling and priming.

6. Slowly por approx 2 to 3 l of the liquid to be pumped throught

the filler neck

7. Screw the filter chamber cover

hand until it stops.

8. Close venting

9. Insert the mains plug into a 230 V mains socket.

CAUTION ! The pump will start immediately !

Once the maximum pressure is reached the pump will switch off

automatically. When the pressure falls below the minimum value

due to water being drawn off, the pump will switch on again

automatically.

The maximum self-priming head of 8 m is only achieved if the

pump is filled until it overflows via the filler connection

delivery hose is held high enough so that no water can escape

via the delivery hose. It is not necessary to hold up the delivery

hose if filled suction hoses with backflow preventer are used.

to the delivery side connection.

DANGER ! Electric shock !

➔ Before filling the pump, unplug the equipment

from the mains.

Warning ! Pump running dry.

➔ Fill the pump to the overflow (approx. 2 to 3 litres)

with water each time before the pump is

switched on.

of the filter chamber by hand.

to FILL.

, until it emerges from the air bleed

and turn rotary switch

closed again, turning by

to RUN.

and the