Gardena 6000/6 inox Premium 1736 Operating Instructions Manual - Page 4
Browse online or download pdf Operating Instructions Manual for Lawn and Garden Equipment Gardena 6000/6 inox Premium 1736. Gardena 6000/6 inox Premium 1736 10 pages. Garden pump
Also for Gardena 6000/6 inox Premium 1736: Operating Instructions Manual (12 pages), Operator's Manual (14 pages), Operator's Manual (10 pages), Operator's Manual (10 pages), Operating Instructions Manual (17 pages)
Print Page
Special mode:
Additional electrical switching devices (e. g. remote control
systems, pressure switches) can be used only in the special mode.
Activating the special mode:
1. When switching on, press the On/Off button
During the first 5 seconds, the green LED is illuminated;
then the LED blinks for 3 seconds.
2. When the green LED illuminates again after 8 seconds,
let go of the On/Off button
Deactivating the special mode:
1. Plug the mains plug into an energised mains socket.
The pump starts of its own accord.
2. Press the On/Off button
3. When switching on, keep the On/Off button
8 seconds until the green LED no longer flashes.
safe-pump-function:
The safe-pump function uses the LED status display to alert the
user that there is no water flow. In addition, it acts as Dry-Run-
ning Safety, guarding against pump damage if the delivery side
is closed too long (e.g. closed valves) or if the water supply fails
(e. g. empty cistern).
LED flashes green:
LED flashes orange:
LED shines red:
LED flashes red:
5. Putting into Storage
Overwintering / Storage:
Before the start of the frost period the Garden Pump should be
stored protected from frost.
1. Open the water drain screw
The Garden Pump drains.
2. Store your Garden Pump so that it is protected from frost.
9
The product must not be added to normal household waste.
Disposal:
(in accordance with
It must be disposed of in line with local environmental regulations.
RL2002/96/EC)
16
ß
for 8 seconds.
8a
ß
.
8a
ß
. The pump switches off.
8a
ß
depressed for
8a
Normal operation
No water flow for at least 20 seconds
No water flow for at least 5 minutes
(pump has switched off automatically)
Alarm! Pump was started 3 times within
20 min. without water flow. (Pump can
no longer be started for 5 min. to allow
cooling, after which the LED shines red)
9
.
6. Maintenance
DANGER! Electric shock!
Risk of injury due to electric shock.
v Disconnect Garden Pump from the mains before
Cleaning the filter:
If the filter is dirty it has to be cleaned.
6
1. Close all shut-off valves,
if any, on the suction side.
2. Unscrew and remove cover
of the filter chamber.
A
3. Draw out filter unit vertically
upwards.
4. Hold beaker
filter
q
draw out 2 (bayonet fitting).
5. Clean beaker
running water and clean the
filter
q
6. Refit filter again in reverse order.
Flush through Garden Pump:
The pump must be flushed through after discharging chlorinated
swimming pool water.
1. Pump through lukewarm water (max. 35 °C), possibly adding
a mild cleaning agent (e.g. detergent) until the pumped water
runs clear.
2. Remove residuals according to the waste disposal laws
applicable in your area.
7. Trouble-Shooting
DANGER! Electric shock!
Risk of injury due to electric shock.
v Disconnect Garden Pump from the mains before
Free the impeller:
An impeller blocked by dirt can be freed again.
v Turn the impeller bolt
This will free the blocked impeller.
"
carrying out maintenance.
6
A
1
0
firmly, turn
0
anti-clockwise 1 and
0
under
e. g. with a soft brush.
trouble-shooting.
w
using a screwdriver.
2
17