Makita 6012HD Instruction Manual - Page 3

Browse online or download pdf Instruction Manual for Drill Makita 6012HD. Makita 6012HD 17 pages.

Print Page

13.

DISCONNECT TOOLS. When not in use, before servicing, and when chang-

ing accessories, such as blades, bits, cutters.

14. REMOVE ADJUSTING KEYS AND WRENCHES. Form habit of checking t o

see that keys and adjusting wrenches are removed from tool before turning

it on.

15. AVOID UNINTENTIONAL STARTING. Don't carry plugged-in tool with finger

o n switch. Be sure switch is OFF when plugging

in.

16.

OUTDOOR USE EXTENSION CORDS. When tool is used outdoors, use only

extension cords intended for use outdoors and so marked.

17. STAY ALERT. Watch what you are doing, use common sense. Don't operate

tool when you are tired.

18. CHECK DAMAGED PARTS. Before further use of the tool, a guard or other

part that is damaged should be carefully checked t o determine that

will

operate properly and perform its intended function. Check for alignment of

moving parts, binding of moving parts, breakage of parts, mounting, and any

other conditions that may affect its operation. A guard or other part that

is damaged should be properly repaired or replaced by an authorized serv-

ice center unless otherwise indicated elsewhere in this instruction manual.

Have defective switches replaced by authorized service center. Don't use

tool if switch does not turn

on and off.

19. GUARD AGAINST ELECTRIC SHOCK. Prevent body contact with grounded

surfaces. For example; pipes, radiators, ranges, refrigerator enclosures.

20.

REPLACEMENT PARTS. When servicing, use only identical replacement parts.

VOLTAGE WARNING: Before connecting the tool t o a power source (receptacle,

outlet, etc.) be sure the voltage supplied is the same as that specified on the

nameplate of the tool. A power source with voltage greater than that specified

for the tool can result in SERIOUS INJURY t o the user - as well as damage t o

the tool. If in doubt, DO NOT PLUG IN THE TOOL. Using a power source

with

voltage less than the nameplate rating is harmful t o the motor.