Makita 6073D Instruction Manual - Page 6

Browse online or download pdf Instruction Manual for Drill Makita 6073D. Makita 6073D 16 pages. Equipped with electric brake 10 mm (3/8”) with fast charger

Print Page
Installing
or
removing battery cartridge
0
Always switch
off
t h e
tool
before insertion or removal
of
t h e battery cartridge.
0
To
remove the battery cartridge, pull
out
t h e set plate on the
tool
and grasp both
sides
of
the cartridge while withdrawing it
from the barrel.
0
To
insert the battery cartridge, align t h e
tongue
on
t h e battery cartridge with t h e
groove in t h e housing and slip it into
place. Snap t h e set plate back into place.
Be sure
to
close t h e set plate fully before
using t h e tool.
0
Do
not use force when inserting t h e battery cartridge.
If the cartridge does not slide in easily, it is not being inserted correctly.
Charging
Plug the fast charger into your power
source. Insert t h e battery cartridge
so
that
the plus and minus terminals o n the bat-
tery cartridge are on the same sides as their
respective markings on t h e fast charger.
Insert the cartridge fully into t h e port
so
that it rests on the charger port floor.
The charging light will come on and charg-
ing will begin. If the charging light does
not come on, press t h e reset button.
I f
the
charging light goes out within 10 seconds
even after pressing the reset button a
couple of times, t h e battery cartridge is dead. (CAUTION : Wait for more than
5
seconds
after t h e charging light goes o u t to press the reset button again.) Replace it with a new
one. When the charging light goes
out
after about one hour, you may remove the fully
charged battery cartridge.
After charging, unplug the charger from the power source.
CAUTION
:
0
Your new battery cartridge is not charged. You will need to charge it before use.
0
If you try to charge a cartridge from a just-operated tool, sometimes the charging light
will not come on. If this occurs, let the cartridge
cool
off for a while. Then re-insert it
and try to charge it once more.
When you charge a new battery cartridge or a battery cartridge which has not been used
for a long period, it may not accept a full charge. This is a normal condition and does
not indicate a problem. You can recharge the battery cartridge fully after discharging
it almost completely a couple of times.
0
If you wish t o charge two battery cartridges, allow
15 minutes between chargings on the
fast charger.
6