Makita 6207DWDE Technical Information - Page 9

Browse online or download pdf Technical Information for Drill Makita 6207DWDE. Makita 6207DWDE 13 pages. Cordless driver drills 10mm, 13mm

Print Page

epair

< 3 > Disassembling gear assembly and motor section See Fig. 3.

Lifting up mode change lever, separated change ring, gear assembly, yoke, armature and endbell from housing

as a set.

Mode change lever

Change ring

< 4 > Assembling leaf spring See Fig. 5.

Assemble leaf spring to housing L as illustrated in Fig. 4.

Leaf spring

Housing L

< 5 > Assembling change ring

When separating gear assembly from housing, change ring can easily slip off from gear assembly.

Re-assemble change ring to gear assembly as follows.

1. Align the widest bulge of spring holder to the bulge of gear assembly by turning spring holder.

2. Assemble change ring by aligning the bulge of change ring's edge to the portion of gear assembly

marked with circle by the bulge of gear assembly.

The widest bulge of

Bulge of

spring holder

gear assembly

Remove as a set without separating from each other.

Yoke

Gear assembly

Armature

Endbell

Bulge of

change ring's edge

Change ring

< Note in disassembling >

Torsion spring 2

Remove so careful that the following springs

do not spring out.

Compression spring 2: installed in mode change

Torsion spring 2: fixing mode change lever

Fig. 3

Housing L

Fig. 4

Bulge of

gear assembly

Bulge of

change ring's edge

Fig. 5

P 9 / 13

Lock lever

Compression spring 2

Mode change lever

Gear assembly

lever.

on gear assembly