Makita 6216DWBE Instruction Manual - Page 5
Browse online or download pdf Instruction Manual for Drill Makita 6216DWBE. Makita 6216DWBE 20 pages.
Print Page
IMPORTANT SAFETY INSTRUCTIONS
FOR CHARGER &
BATTERY CARTRIDGE
I.
SAVE THESE INSTRUCTIONS
- This manual
contains important safety and operating instructions for battery charger.
2. Before using battery charger, read all instructions and cautionary markings
on (1) battery charger,
(2)
battery, and
(3)
product using battery.
3.
CAUTION - To reduce risk of injury, charge only MAKITA Battery Cartridge
7000, 7001, 7002, 7033, 7100, 7120,
9000,
9001,
9002,
9033, 9100,
9101,9102,9120,9122,9133,1200,1201,1202,1210,1211,1222,1233,
1422, 1433,9101A. 9102A, 1201A or 1202A. Other types of batteries may
burst causing personal injury and damage.
4. Do not expose charger t o rain or snow.
5. Use of an attachment not recommended or sold by the battery charger
manufacturer may result in a risk of fire, electric shock, or injury t o persons.
6. To reduce risk of damage t o electric plug and cord, pull by plug rather than
cord when disconnecting charger.
7 . Make sure cord is located so that it will not be stepped on, tripped over, or
otherwise subjected t o damage or stress.
8. A n extension cord should not be used unless absolutely necessary. Use of
improper extension cord could result in a risk of fire and electric shock. If
extension cord must be used, make sure:
a. That pins on plug of extension cord are the same number, size, and shape
b. That extension cord is properly wired and in good electrical condition; and
c. That wire size is at least as large as the one specified in the table below.
TABLE 1
RECOMMENDED MINIMUM AWG SIZE FOR
EXTENSION CORDS FOR BATTERY CHARGERS
as those of plug on charger;
I
Length of Cord (Feet)
I
25
I
50
I
100
I
1 5 0
I
AWG Size of Cord
I
18
I
18
I
18
I
16
I
9.
Do not operate charger
with
damaged cord or plug - replace them im-
mediately.
I O . Do not operate charger if
it has received a sharp blow, been dropped, or other-
wise damaged in any way; take it t o a qualified serviceman.
11. Do not disassemble charger or battery cartridge; take
it
t o a qualified
serviceman when service or repair is required. Incorrect reassembly may
result
in
a risk
of
electric shock or fire.
12. To reduce risk of electric shock, unplug charger from outlet before attempt-
ing any maintenance or cleaning. Turning off controls will not reduce this risk.
5