Ceyear 4024F Maintenance Manual - Page 18

Browse online or download pdf Maintenance Manual for Measuring Instruments Ceyear 4024F. Ceyear 4024F 19 pages. Spectrum analyzer

Print Page

Test steps

Connect the computer with the spectrum analyzer with a point-to-point network cable; connect the

BNC cable with 10 M reference input of the spectrometer and 10 M reference output of the signal

source, and then connect the 2.4 mm (m-m) low loss RF cable with the 1465H signal generator, and

finally connect the spectrometer RF input with the 2.4mm (m-m) low loss RF cable with 2.4 mm (f-f)

adapter. (When testing the 4024D/E, use the 2.4 mm (m)-N (m) adapter; when testing the 4024F/G,

use the 2.4 mm (f-f) adapter). Connect the computer with the signal generator with the GPIB card

and GPIB cable, as shown in the following figure.

Fig. 15 Schematic Diagram of Connection of the Automatic Test

Open 4024AutoTest.exe, and the interface is as follows:

Fill in the communication parameters in the communication parameter setting column, including the

IP address of the spectrometer, signal source address (1465H), and power meter address. The

address of the signal source and power meter can be inquired through System menu. If the GPIB

number of the signal source is 19, no modification is required; similarly, if the GPIB number of the

power meter is 13, no modification is required. The IP address of the spectrometer can be inquired

GPIB card

Signal source

Network cable

Fig. 16 Interface of the Automatic Test of Indexes

10MHz out

BNC cable

Adapter

2.4 mm cable

Adapter

10MHz in

Spectrum analyzer