Makita 6302H Instruction Manual - Page 8

Browse online or download pdf Instruction Manual for Drill Makita 6302H. Makita 6302H 11 pages. Makita 6302h drill: specifications
Also for Makita 6302H: Instruction Manual (13 pages), Parts Breakdown (2 pages)

Print Page

OPERATION

Drilling operation

Drilling in wood

When drilling in wood, best results are obtained with wood drills equipped with a

guide screw. The guide screw makes drilling easier by pulling the bit into the work-

piece.

Drilling in metal

To prevent the bit from slipping when starting a hole, make an indentation with a cen-

terpunch and hammer at the point to be drilled. Place the point of the bit in the inden-

tation and start drilling.

Use a cutting lubricant when drilling metals. The exceptions are iron and brass which

should be drilled dry.

CAUTIO N :

Pressing excessively on the tool will not speed up the drilling. In fact, this excessive

pressure will only serve damage the tip of your bit, decrease the tool performance

and shorten the service life of the tool.

There is a tremendous force exerted on the tool/bit at the time of hole break through.

Hold the tool firmly and exert care when the bit begins to break though the workpiece.

Always grip the small workpiece firmly with

vise or a holding means.

A stuck bit can be removed simply by setting the reversing switch to reverse rotation

in order to back out. However, the tool will pull away easily unless you hold it firmly

before starting the tool.

MAINTENANCE

CAUTIO N :

Always be sure that the tool is switched off and unplugged before attempting to perform

inspection or maintenance.

To maintain product SAFETY and RELIABILITY, repairs, carbon brush inspection and

replacement, any other maintenance or adjustment should be performed by Makita

Authorized or Factory Service Centers, always using Makita replacement parts.

ACCESSORIES

The accessories listed in this manual are available at an extra cost from your Makita distributor or Makita factory

service center. Service centers are listed on the warranty card packed with your tool.

CAUTION:

These accessories or attachments are recommended for use with your Makita tool specified in this

manual. The use of any other accessories or attachments might present a risk of injury to persons. The

accessories or attachments should be used only in the proper and intended manner.

Chuck key

Part

No. 763434-5

Grip assembly

Part

No. 122593-8

Depth gauge

Part

No. 415486-9