AlienTek DP100 User Manual - Page 7

Browse online or download pdf User Manual for Portable Generator AlienTek DP100. AlienTek DP100 18 pages. Digital power

Print Page

1. 2，Technical Parameter

③ When we need output 5V from USB-A interface, or use a mouse (wired and wireless) to control the

device, please set the USB-A interface to the host mode (USBH), then connect the mouse/mouse wireless receiver.

First do not move the mouse, then roll the mouse wheel until the device emits a beeping sound (when the mouse

wheel is detected), the left, middle, right buttons and the scroll wheel of the mouse correspond to the 3 buttons and

scroll wheel of DP100 one-to-one, and the functions are the same (after shutdown or switching to slave mode, the

mouse control is invalid ).

4.2.2 Operation instructions

Click the middle button ■ to enter the parameter setting state, click ■ again to switch the

output voltage setting and constant current setting cyclically， After the parameter bit is highlighted,

click the  or  to move the parameter highlight position left or right, and then adjust the

highlighted value by scroll wheel, as shown in Figure 4.2.2:

After the parameter adjustment is completed, you can long press any key to exit the

parameter setting. Timeout (8Sec) automatically exited parameter setting.

In the parameter setting state, the functions of the buttons and the scroll wheel are shown in

Table 4.2.1:

Buttons

Click

Left

Shift left the highlighted bit

Middle■

Switch voltage and current parameter

Right

Shift right the highlighted bit

Wheel

Adjust the highlighted value

After exit parameter setting，buttons function are shown in Table 4.2.1:

Buttons

Click

Left

Power on while off

Middle■

Enter parameter setting

Right

Enable/Disable output

Change output mode, including OFF mode, constant voltage mode CV and constant current

mode CC, as shown in Figure 4.2.3:

User Manual

DP100 Digital Power User Manual

Figure 4.2.2 Parameter setting

Double-Click

None

Table 4.2.1 Button and Wheel function

Double-Click

Change USB-A interface mode

Switch to Menu Interface

Change supply voltage(PD/QC mode)

Table 4.2.2 Button function

Figure 4.2.3 Output mode

High Performance Digital Power

Long-Press

Exit parameter setting

Long-Press

Power off while on

Lock/Unlock panel

Switch to Preset Interface