A&S Studio Bar 200 User Manual - Page 9

Browse online or download pdf User Manual for Speaker System A&S Studio Bar 200. A&S Studio Bar 200 16 pages. 2.1 bar with built-in subwoofer 200

Print Page
Do not use any batteries other than those specified.
3
Do not heat or disassemble batteries.
4
Never throw them in fire or water.
Do not carry or store batteries with other metallic objects. Doing so could cause batteries to short
5
circuit, leak or explode.
Never recharge a battery unless it is confirmed to be a rechargeable type.
6

Placement and Mounting

Placement

A If your TV is placed on a table, you can place the
unit on the table directly in front of the TV stand,
centered with the TV screen.
B If your TV is attached to a wall, you can mount
the unit on the wall directly below the TV screen.

Wall mounting

•
Installation must be carried out by quali ed personnel
only. Incorrect assembly can result in severe personal
injury and property damage (if you intend to install this
product yourself, you must check for installations such as
electrical wiring and plumbing that may be buried inside
the wall). It is the installer's responsibility to verify that the
wall will safely support the total load of the Soundbar and
wall brackets.
•
Additional tools (not included) are required for the
installation.
•
Do not overtighten screws.
•
Keep this instruction manual for future reference.
•
Use an electronic stud nder to check the wall type
before drilling and mounting.
Remove the screws from the main unit.
1
Attach the wall brackets to the main unit with
the screws removed from the main unit.
screw out
screw in
A
2
Drill 2 parallel holes (Ø 3-8 mm each according
to wall type) in the wall. The distance between
the holes should be 580 mm.
W A L
3
Firmly x 1 dowel into each hole in the wall
if necessary.
Dowel
Insert 1 screw into each hole or dowel. Leave a
4
5 mm gap between the wall and the screw's head.
Lift the unit with the attached wall brackets over
the heads of the screws and slot into place.
B
L
5 mm
25-30 mm
9