AC Hydraulic WT1000 User Manual - Page 3

Browse online or download pdf User Manual for Construction Equipment AC Hydraulic WT1000. AC Hydraulic WT1000 16 pages. Hydraulic wheel removal trolley

Print Page

WT1000

WARnInG -

safe usage instructions

1. study, understand, and follow all instructions

before operating this device.

2. Do not exceed rated capacity.

3. Use only on hard, level surface.

4. Apply load as close to the hydraulic cylinder as

possible.

5. Assure that the load cannot tilt while lowering or

moving.

6. Before moving, center the load and secure it with

the chain. Then lower to the lowest possible point.

7. no alterations shall be made to this product.

8. Failure to follow these warnings may result in loss

of load, personal injury and/or property damage.

Assembly

Oil mechanical parts before first use, and then

regularly.

Use

Lifting: centre the wheel removal trolley around the

load and operate the pumping pedal.

Lowering: slowly turn the release handle (33) counter

clockwise. The release will close automatically when

letting go of the handle.

Transport: before transportation, lower and centre the

load, and fasten it with the chain (15).

Maintenance

Maintenance and repair must always be carried out

by qualified personnel. Always use genuine jack

manufacturer supplied parts only.

Daily: check the wheel removal trolley for damages.

Monthly: lubricate moving parts with high-quality oil.

Grease end of pump piston (27).

Oil refill and check: lower the lifting frame to lowest

position and remove the cylinder filler plug (24).

Correct oil level is to lower edge of hole for filler plug.

You may have to refill with an oilcan.

Quantity of oil: 0,8 l. Any good hydraulic oil with

viscosity IsO VG 15 can be used.

Never use brake fluid!

Safety inspection

In accordance with national legislation - minimum

once a year though - the wheel removal trolley must

be inspected by an expert: bottom and lifting frame for

damages and abnormal wear and tear, greasing and

oiling, hydraulic unit for leaks.

Possible faults and how to overcome them

1. The wheel removal trolley does not lift to maximum

position but does hold the load: check oil level.

2. Bad pump function (half strokes only): there is

vacuum in the reservoir due to too much oil. lower

the lifting frame completely and let surplus oil drain

at filler plug (24).

3. The load is dropping: verify that the release is

properly closed. Pre tension of the spring (35) is

max. half a turn. If the load is still dropping the

hydraulic unit needs repair (leaking non-return

valves in the pump or worn seals).

Spare parts

Replace worn or broken parts with genuine jack

manufacturer supplied parts only. All major parts may

not be provided after discontinuation of the model.

Destruction

Oil must be drained off and legally disposed of.