Garmin 15L Technical Specifications - Page 30

Browse online or download pdf Technical Specifications for GPS Garmin 15L. Garmin 15L 40 pages. Garmin gps 15l: reference guide
Also for Garmin 15L: Reference Manual (1 pages)

Print Page

APPENDIX C: CHANGING THE BAUD RATE IN GARMIN MODE

In certain cases, you may need to change the default baud rate of your Garmin GPS receiver

while in Garmin mode. Follow these steps to temporarily change the baud rate.

Refer to the Garmin Device Interface Specification found in the Garmin Device Interface SDK for

details on how to form and parse Garmin packets, available at

https://www8.garmin.com/support/commProtocol.html.

1. Turn off all requests by transmitting packet:

2. The GPS unit will respond by sending a packet with id = IOP_ACK_BYTE (0x06)

3. After you receive the above packet, transmit packet:

4. The GPS unit will respond by sending a packet:

5. Determine the actual baud rate value from the data sent in step 4. This value will be within +/-

5% of the actual baud rate. (For example, the GPS unit might send a baud rate of 38361,

which correlates to a baud rate of 38400).

6. If the baud rate in step 5 is acceptable, transmit packet:

7. Sleep for a small amount of time, about 100 milliseconds, to make sure the packet in (6) was

successfully transmitted to the GPS unit.

8. Close the current connection to the GPS unit and immediately open a new connection with

the new baud rate obtained in step 5.

9. Immediately after establishing a connection, transmit packet:

10. The GPS will respond by sending a packet:

11. After you receive the above packet, transmit the same packet in step 9 again.

12. The GPS will respond again with the same packet in step 10.

13. The baud rate has been successfully changed upon receiving the above packet. If the GPS

unit does not receive these two IOP_CMND_DATA packets within two seconds, it will reset

its baud rate to 9600.

id = IOP_RQST_DATA (0x1C)

data = 0 (16-bit unsigned integer )

id = IOP_BAUD_RQST_DATA (0x30)

data = baud rate to change to (32-bit unsigned integer; for example,

38400)

id = IOP_BAUD_ACPT_DATA (0x31)

data = highest acceptable baud rate closest to what was requested

(32-bit unsigned integer; for example, 38361 decimal)

id = IOP_ACK_BYTE (0x06)

data = IOP_BAUD_ACPT_DATA (0x31)

id = IOP_CMND_DATA (0x0A)

data = IOP_ACK_PING (0x3A)

id = IOP_ACK_BYTE (0x06)

data = IOP_CMND_DATA (0x0A)

id = IOP_CMND_DATA (0x0A)

data = IOP_ACK_PING (0x3A)

id = IOP_ACK_BYTE (0x06)

data = IOP_CMND_DATA (0x0A)