Alinco DR-510T Instruction Manual - Page 8

Browse online or download pdf Instruction Manual for Transceiver Alinco DR-510T. Alinco DR-510T 16 pages. Vhf/uhf dual band fm transceiver
Also for Alinco DR-510T: Instruction Manual (8 pages)

Print Page
FUNCTION Operation
Whenever the F key is pressed, the
"M" indicator will flash. You must com-
plete Ihe desired programming within 5
seconds, or the "M" indicator will turn
off or stop flashing. In that case, you
must press the F key again.
The F key is used with secondary
functions printed in blue on the trans-
ceiver function keys.
1. VHF/UHF Band Selection
To select the desired band, press
the F key and then the BAND key.
Each time you press the keys, VHF
and UHF will be selected alternate-
ly-
2. Frequency Step Selection
The frequency
Step
can
be
selected by using the following
procedure:
A. Press the VFO/M key to select
the VFO mode.
B. Press the F key and then the
CH.SP key.
C. Select the desirea frequency
Step using the Main Dial or the
microphone
UP/DOWN
but-
tons.
The
example
below
Shows the order, in which the
Main Dial (or UP/DOWN but-
tons) will increase or decrease
the spacing.
^ 5 kHz
^ 25 kHz
20 kHz
10 kHz
12.5 kHz
■15 kHz
D. Press the F key again or PTT
Switch to return to VFO mode.
3. Key Lock
A. Press the F key, and then press
the Lock key again.
B. The "L" indicator will replace
the Memory number shown on
right side of display.
C. Stops all function keys except
the PTT Switch.
D. To cancel this function, press
the F key and the LOCK key
again.
4. BEEPON/OFF
A. Press the F key, and then press
the BEEP key.
B. Repeating this procedure, beep
will turn ON and OFF alter-
nately.
5. Memory Sklp
The Memory Channel Skip function
allows you to temporarily skip un-
wanted Memory Channels during
Memory Channel Scanning.
A. Press the VFO/M key to select
the Memory Channel mode.
B. Select the Memory Channel
that you want to skip using the
Main Dial or the microphone
UP/DOWN buttons.
Press F key, and then press the
SKIP key. The decimal point
between MHz and kHz will dis-
appear from the display.
C. A frequency in memory without
the decimal point will be skip-
ped when scanning memories.
D. To cancel Memory Channel
Skip, press the F key and the
SKIP key again.
- 8 -