Alinco DR-135T MkII Quick Manual

Browse online or download pdf Quick Manual for Radio Alinco DR-135T MkII. Alinco DR-135T MkII 3 pages.
Also for Alinco DR-135T MkII: Quick Manual (2 pages)

Print Page

Alinco DR-135T Quick Guide

Push to Talk

Basic Operation:

1. Power on the radio by pressing the yellow Power button (1).

2. Adjust Volume level by turning the Volume knob (2) clockwise to increase volume,

counterclockwise to decrease volume.

3. Adjust the Squelch setting:

Press and release the Squelch key (9). You should see a SQL icon on the left side of the

display.

b. Under the SQL icon is a two digit number indicating the Squelch Level. The Squelch

level may be adjusted anywhere between 0 (lowest setting) and 20.

Adjust the Squelch Level by rotating the main Dial (3). Start at the lowest Squelch Level

and rotate clockwise until there is no noise from the speaker.

d. To select and store the Squelch Level, press and release the FUNC key (4).

4. Most frequencies are pre-programmed into the radio's memory channels. To access the memory

channels, press and release the V/M button (5).

An M icon will appear on the left side of the display to indicate the radio is in Memory

Mode. Below the M is the Memory Channel number.

b. The display shows the Frequency that the radio is tuned to for that memory location.

There may be additional information indicating repeater offset and CTCSS Tone for

repeater operation appearing on the display.

Memory

Mode

To select a different Memory Channel, rotate the Dial (3) clockwise to increase the

channel number, counterclockwise to decrease the channel number. Using your frequency

list, find the frequency that you will be using by scrolling through the Memory Channels.

i. If the Frequency that you will be using is not stored in one of the Memory

5. When you have found the frequency desired in one of the pre-programmed channels: to transmit

press and hold the Push to Talk button (11) on the Microphone (10). Release the Push to Talk

button to receive.

(11)

Function/

V/M

Set

(5)

(4)

Locations, go to "Basic VFO Mode".

MHz

TCS

Squelch (9)

Shift

DCS

(6)

(7)

Power Level (8)

Microphone (10)

Volume (2)

Power (1)

Dial (3)

Frequency for

This Memory

Location