Alinco DJ-196 Instruction Manual - Page 6
Browse online or download pdf Instruction Manual for Two-Way Radio Alinco DJ-196. Alinco DJ-196 18 pages. Vhf/uhf fm transceiver
Also for Alinco DJ-196: Instruction Manual (20 pages)
Print Page
30kHz to either 12.5kHz or 25kHz, or changed in reverse, the frequency and shift
width may be compensated.
5-7 Shift Direction and Offset Frequency
Usually the repeater is used in the duplex mode.
Namely the signal received with a certain frequency is transmitted with another frequency.
The difference between these frequencies is the offset frequency. The setting range
of the offset frequency is from 0 to 99.995MHz.
1. Press and hold the F key, then press 2/SHIFT key while [F] icon is ON. The
current offset frequency and shift direction will appear. Then each time 2/SHIFT
key is pressed, the shift direction toggles as follows:
........ -0.60....... +0.60........OST-OF.........
.......................................................
2. While shift frequency is d isplayed, rotating the dial clockwise increases the
frequency by 1 channel step/1 click and rotating the dial counterclockwise decreases
the frequency by 1 channel step/1 click.
3. Press and hold the F key, then rotate the dial. The frequency increases or
decreases by 1MHz depending on the rotating direction.
Press any key (except for MONI and FUNC keys) to complete the setting. The LCD returns to
the ordinal mode.
4. The Lamp and MONI keys are activate while shift frequency is displayed on the LCD.
Also the setting can be completed by pressing 2/STEP key while holding the FUNC key.
5-8 Memory Channel Operation
This unit is provided with 40 memory channels (0-9 CH) and one call channel (C).
The memory can not be increased.
(1) Calling of memory channel
1. Press V/M key, and [Ｍ] will appear on the LCD indicating the unit enters the
memory mode. [M] icon flashes to show the CH's memory has not been programmed,
and the VFO frequency is displayed.
2. Rotating the dial clockwise increases the memory channel number by 1 channel.
Rotating the dial counterclockwise decreases the memory channel number by 1 channel.
(2) Programming a memory channel
【 Memory Programming 】
1. In VFO mode select the desired frequency, then set Shift and Tone Function as necessary.
2. Press V/M key to enter the memory mode.
3. Rotate the dial to select the desired memory channel number.
4. The unprogrammed memory CH's number flashes.
5. Press and hold the FUNC key, then press the MW key while FUNC icon is ON. A
beep sounds indicating the completion, and the VFO frequency has been
programmed in the selected memory channel.
*If a memory CH whose memory has been programmed is selected at 4. in the
operation of 5. the memory will be erased and [M] will start flashing.
6. When CH-C is selected, the CALL channel is also reprogrammed.
[C] will not flash.
The content of the memory should be erased beforehand to be reprogrammed.
(3) Erasing of a memory channel
1. Press the V/M key to select the memory mode.