Garmin NavComm SL30 User Manual - Page 19

Browse online or download pdf User Manual for Car Navigation system Garmin NavComm SL30. Garmin NavComm SL30 48 pages. Vhf transceiver
Also for Garmin NavComm SL30: Quick Reference Manual (2 pages), Installation (2 pages)

Print Page

Nav Radio Mode

Monitoring the Standby Nav channel

The Nav radio provides a monitor function for VORs as

the standby channel similar to the Comm radio. The

monitor function is activated or deactivated by pressing

NAV

the

radial for the standby channel is shown in parentheses

when the VOR monitor mode is activated. This replaces

the station identifier, OBS course, or VOR/LOC indicator.

A small "m" will replace the "s" in front of the Standby

frequency. The Standby VOR radial is updated once per

second. You cannot monitor a Localizer channel.

111.80 m117.40 (267)

If no signal can be tracked on the standby channel, then it

will be dashed out.

111.80 m115.40 (---)

The VOR Monitor function is turned off when you

flip/flop frequencies, recall a frequency, or press

again. Monitoring is not canceled by switching to Comm.

Using the Standby Channel to Monitor a Second VOR

You can use the monitor function of the Standby channel

as if it were a second Nav receiver. This is useful to check

for crossing points on the course you are navigating along.

The two following examples show how to monitor the

second channel. You can use these examples to develop

your own solutions for other in-flight navigation needs.

button while in the Nav function. The From

Advanced Operation

from 115

NAV