Garmin ECHOMAP ULTRA 106sv Installation Instructions Manual - Page 2

Browse online or download pdf Installation Instructions Manual for Marine GPS System Garmin ECHOMAP ULTRA 106sv. Garmin ECHOMAP ULTRA 106sv 13 pages.

Garmin ECHOMAP ULTRA 106sv Installation Instructions Manual

Tools Needed

• Drill
• Drill bits
◦ Bail mount: drill bits and screws appropriate for the surface and hardware
◦ Flush mount: 3.2 mm (
• #2 Phillips screwdriver
• Jigsaw or rotary tool
• File and sandpaper
• Marine sealant (optional)

Mounting Considerations

You can flush mount the device in the dashboard or bail mount the device on the dashboard.
When selecting a mounting location, observe these considerations.
• The mounting location must provide a clear view of the screen and access to the keys on the device.
• The mounting location must be sturdy enough to support the device and the mount.
• The cables must be long enough to connect the components to each other and to power.
• To avoid interference with a magnetic compass, do not install the device closer to a compass than the
compass-safe distance value listed in the product specifications.

Bail Mounting the Device

If you are mounting the bracket on fiberglass with screws, it is recommended to use a countersink bit to drill a
clearance counterbore through only the top gel-coat layer. This will help to avoid cracking in the gel-coat layer
when the screws are tightened.
1 Select the mounting hardware appropriate for your mounting surface and for the bail-mount bracket.
2 Using the bail-mount bracket
3 Using a drill bit appropriate for the mounting hardware, drill the four pilot holes.
4 Using the selected mounting hardware, secure the bail-mount bracket to the mounting surface.
5 Place the cradle
into the bail-mount bracket, and tighten the bail-mount knobs
6 Connect all necessary cables to the cradle
to lock the cables to the cradle.
To prevent corrosion of the metal contacts, cover unused connectors with the attached weather caps.
2
1
3
/
 in.) and 9.5 mm (
/
 in.) drill bits
8
8
as a template, mark the pilot holes
(Connector View,
NOTICE
.
page 4), and spin the locking rings clockwise
NOTICE
.