Garmin Fishfinder 160 Blue Owner's Manual - Page 12
Browse online or download pdf Owner's Manual for Marine GPS System Garmin Fishfinder 160 Blue. Garmin Fishfinder 160 Blue 50 pages. Garmin fishfinder 160 blue owner's manual
Also for Garmin Fishfinder 160 Blue: Specifications (2 pages)
Print Page
www.reelschematic.com
www.reelschematic.com
Installation
Mounting the Transducer/
Speed Sensor
Weight transducer in place
Apply twisting motion
for at least 24 hours
to eliminate any
trapped air bubbles
Installing the Transducer
OK
Adjust the speed sensor so it is parallel with the bottom
of the boat. If the speed sensor is not adjusted properly,
the sonar may experience inaccurate or degraded speed
readings.
4
In-Hull Installation (continued)
Installing the Transducer:
1. Lightly sand the surface of the hull and face of the transducer with 400
grit wet or dry sandpaper.
2. Build a dam using strip caulk about 1/4" tall. Pour about 1/8" of 2-part,
slow cure epoxy in the dam. Place the transducer in the epoxy, turning
the transducer to work out any air bubbles.
3. Weight the transducer in place and allow to cure for 24 hours.
Slow cure
Speed Sensor Installation
2-part epoxy
The speed sensor should be mounted as near the center of the boat
as possible. Like the transducer, for the speed sensor to operate properly,
it should be located in non-turbulent water. Follow the directions in the
speed sensor installation instructions to assemble the speed sensor with
the mounting bracket, drill holes in the transom, mount the assembly and
Strip Caulk or
route the cable.
RTV Sealer
Drill a 3/4" hole well above the water line.
Coat the inside of the hole with Marine Sealant.
Position Cable Clamps about one-third of
the distance from the hole to the transducer.
Drill 1/8" pilot holes 3/8" deep for the mounting screws.
Coat the screws with Marine Sealant before installing them.