Garmin GPSMAP 17 Installation Instructions Manual - Page 7

Browse online or download pdf Installation Instructions Manual for Marine GPS System Garmin GPSMAP 17. Garmin GPSMAP 17 16 pages. Gps receiver/antenna
Also for Garmin GPSMAP 17: Installation Instructions Manual (12 pages), Installation Manual (16 pages), Reference Manual (1 pages), Technical Reference (30 pages), Installation Instructions Manual (17 pages), Installation Instructions Manual (19 pages), Declaration Of Conformity (1 pages), Technical Specifications (40 pages), Quick Start Manual (16 pages)

Print Page

To attach the enclosed pole mount to the GPS 17:

1. Thread the cable though the pole mount.

2. Align the tab on the mount to the notch on the GPS 17.

3. Use the enclosed screws to secure the mount to the base.

Attaching the Pole Mount to the GPS 17

GPSMAP 2106/2110 & GPS 17

Align Notch

To mount the GPS 17 with the cable run outside the

mount:

1. Place the cable in the vertical slot along the side of the base of

the unit.

2. Screw the GPS 17 onto the mount. DO NOT overtighten the

head. It is possible to over tighten the unit and cut the cable.

3. With the GPS 17 and mount installed, ﬁll the remaining gap in

the cable exit with a marine sealant.

4. Route the cable away from sources of electronic interference.

To mount the GPS 17 with the cable run through the

mount:

1. Position the mount in the preferred location and mark the

approximate center of the mount.

2. Drill a hole large enough for the cable to pass through.

3. Slide the cable through the mount, and then screw the GPS 17

onto the mount.

4. Fasten the mount to the boat.

5. Route the cable away from sources of electronic interference.

Cable run internally

Attaching the GPS 17 to a Pole Mount

NSTALLATION

NSTRUCTIONS

Cable run externally