Garmin GPSMAP 2010 Installation Manual - Page 3

Browse online or download pdf Installation Manual for Marine GPS System Garmin GPSMAP 2010. Garmin GPSMAP 2010 8 pages. Garmin gsd 20 marine-remote sounder: release note
Also for Garmin GPSMAP 2010: Installation Instructions Manual (12 pages), Declaration Of Conformity (1 pages), Declaration Of Conformity (1 pages), Owner's Manual (20 pages)

Print Page

GPSMAP 2006 / 2010 / GPS 17N Installation Guide

Flush Mounting the GPSMAP 2006/2010:

1. Trim the Flush Mount Template and tape in the desired location.

2. Using the Center Punch, indent the center of each Mounting Hole location.

3. Using an 1/8" (3mm) drill bit, drill the four Mounting Holes.

4. Using a 3/8" (6mm) drill bit, drill a hole for a location to begin cutting the mounting surface.

5. Using the Jig Saw, cut the mounting surface along the inside of the dashed line indicated on

the template. Be very careful when cutting this hole, there is only a small amount

of clearance between the unit and the Mounting Holes.

6. Install the four Mounting Studs into unit by screwing the shorter, threaded section in to the

back of the unit. Use a 1/16" (2mm) Allen Wrench to tighten the Mounting Studs until the

stop contacts the case. Be careful not to overtighten as this may damage the Mounting

Stud! The studs have a reusable thread-locking patch pre-applied from the factory.

7. Place the unit in position in the cut out in the mounting surface.

8. Place washers over the Mounting Studs, then thread on one Hex Nut per Mounting Stud.

Tighten all four until the unit is snug against the mounting surface. Install and tighten the

second Hex Nut on all four Mounting Studs to lock the ﬁ rst one in place.

2010 FLUSH MOUNT TEMPLATE

MOUNTING HOLE

TRIM TEMPLATE ALONG THIS

LINE TO AID FITTING

UNIT OUTLINE

CUT MOUNTING SURFACE

ALONG INSIDE OF THIS LINE

Drill four 3mm (1/8") mounting holes at the

indicated locations.

Mount the unit with 3mm machine screws. The

length will depend on the thickness of the surface

that you are mounting the unit on.

DRILL A 3/8" HOLE.

BEGIN CUTTING HERE

When mounting the unit make sure that the 3mm

screws will not extend further than 4mm into the

unit. If the screws are too long, they may damage

the unit.

MOUNTING HOLE

Garmin International 1200 E. 151 st Street, Olathe, KS 66062 Part Number 190-00244-00

May 2001 Printed in Taiwan

Flush Mount Template