Garmin TR-1 Gold Owner's Manual - Page 9

Browse online or download pdf Owner's Manual for Marine GPS System Garmin TR-1 Gold. Garmin TR-1 Gold 38 pages. Throttle actuator
Also for Garmin TR-1 Gold: Basic Operation Manual (9 pages), Quick Reference (2 pages), Mounting Instructions (7 pages), Installation Instructions (4 pages), Owner Handheld Quick Reference (2 pages)

Print Page

You should gather the following tools before beginning installation. See throttle and cylinder

supplements for any additional tools that may be needed for your application.

Tools

Power Drill

#1 Phillips screw driver

.125 (1/8) or 3.17 mm dia. drill

.469 (15/32) or 11.90 mm dia. drill

Roll of masking tape

Rags

Knife

Pliers

Silicone RTV

Loctite or similar product

Electrical grease compound

(Dow Corning #4)

Installation of The Electro-Hydraulic Unit

Please read the complete instructions thoroughly before starting your installation. If

you have any questions call our Tech Support line. 1-800-588-7655

Fig. 5

Tools

Fig .4

Locate the Electro-Hydraulic unit where it

it will not be subjected to water submersion

or spray from wash down.

Step one (Template)

Find the mounting template in your autopilot

documentation package. Use the wall or floor

section of the template as needed. Decide which

screw type you need. Hold the template in the

place with tape and drill right through it in the

three indicated locations. See fig.5. Remove

template and install screws in the indicated

locations on template. Tighten these 2 screws

down to 3/32" from the surface to allow enough

space for the bracket on the pump to slide behind

the screw.