Garmin AIS 300 Installation Instructions Manual
Browse online or download pdf Installation Instructions Manual for Marine Equipment Garmin AIS 300. Garmin AIS 300 8 pages. Technical reference for garmin nmea 2000 products
Also for Garmin AIS 300: Declaration Of Conformity (6 pages), Technical Reference (42 pages), Installation Instructions Manual (8 pages)
Print Page
Use these instructions to install the Garmin
of this package with the packing list on the box. If any pieces are missing, contact your Garmin dealer immediately.
Use the following instructions to install the AIS 300 device. Details for the following steps are included in this document:
1. Select locations for the AIS components.
2. Mount the AIS 300 receiver box.
3. Connect the AIS 300 to power.
4. Connect the AIS 300 to a VHF antenna and to an optional VHF radio (page 4).
5. Connect the AIS 300 to a NMEA 2000 network or to a NMEA 0183-compatible chartplotter (optional - page 4).
When navigating, carefully compare information provided by the unit to all available navigation sources, including information from visual
sightings, local waterway rules and restrictions, and maps. For safety, always resolve any discrepancies or questions before continuing
navigation.
Use this unit only as a navigational aid. Do not attempt to use the unit for any purpose requiring precise measurement of direction, distance,
location, or topography.
This product, its packaging, and its components contain chemicals known to the State of California to cause cancer, birth defects, or
reproductive harm. This Notice is provided in accordance with California's Proposition 65. See
information.
Wear safety goggles and a dust mask when drilling, cutting, or sanding.
Safe Compass Distance
Ensure that you install the AIS 300 receiver box at least 15
correctly when the AIS 300 is operating.
Selecting Locations for the AIS 300 Components
Use the wiring layout diagrams starting on
cables reach all components before permanently mounting any component.
Mounting the AIS 300 Receiver Box
Install the AIS 300 receiver box below deck on a bulkhead. Select a location that is dry and protected from washdown. Ensure that the
location is well ventilated and away from objects that generate heat. Ensure that the receiver box is at least 15
compass to avoid interference.
Needed tools
•
Drill and drill bits
•
Number 2 Phillips screwdriver
to mount the receiver box:
1. Ensure that the chosen location is dry, protected from washdown, and well-ventilated.
2. Use the receiver box as a template, and use a pencil to mark the holes in the four corners. Do not drill through the receiver box.
3. Drill four
/
in. (3 mm) pilot holes.
1
8
4. Mount the receiver box using the included 20 mm M 3.5 screws. You can also use bolts, washers, and nuts (not included) to mount the
receiver box if the mounting surface is suitable.
March 2010
AIS 300 Installation Instructions
AIS 300 Automatic Identification System (AIS) Class B receiver device. Compare the contents
®
WARNING
CAutIoN
/
in. (40 cm) from any compass. Test your compass to verify that it operates
3
4
page 2
to determine how to best organize the AIS 300 components on your boat. Ensure that the
190-01178-00 Rev. B
www.garmin.com/prop65
for more
/
in. (40 cm) from any
3
4
Printed in China