Garmin Boat Switch Installation Instructions Manual - Page 18
Browse online or download pdf Installation Instructions Manual for Marine Equipment Garmin Boat Switch. Garmin Boat Switch 27 pages. Pre-configured digital switching system
Print Page
Switch Configuration
By default, the Garmin chartplotter software is configured so that activating a switch on the chartplotter screen
sends a latching signal a connected digital switching device. Because the Garmin Boat Switch device is
designed to provide both latching and momentary switches within the switching device, the chartplotter must be
configured so that a momentary signal is sent to the Garmin Boat Switch device instead. This allows the Garmin
Boat Switch device to activate the appropriate switch type (either latching or momentary) within the device
based upon the channel.
You must configure all of the following switches as momentary in the chartplotter software for proper operation
(Configuring a Switch as Momentary, page
Switch Number
1
2
3
4
5
9
10
11
12
13
17
18
19
20
21
25
26
27
Configuring a Switch as Momentary
All latching and momentary channels on the Garmin Boat Switch device must be configured in the chartplotter
software as momentary switches for proper operation.
1 From a Garmin chartplotter connected to the same NMEA 2000 network as the Garmin Boat Switch device,
select Options > Settings > My Vessel > Switching > NMEA Standard.
2 Select the switch number.
3 Select Configuration > Momentary.
18
18).
Switch Name/Wire Label
CH 1-TOGGLE 1(5A)
CH 2-TOGGLE 2(5A)
CH 3-TOGGLE 3(5A)
CH 4-TOGGLE 4(5A)
CH 5-TOGGLE 5(5A)
CH 9-TOGGLE 6(10A)
CH 10-TOGGLE 7(10A)
CH 11-LIVEWELL(10A)
CH 12-BILGE 1 MANUAL(10A)
CH 13-BILGE 2 MANUAL(10A)
CH 17-DIMMABLE 1(10A)
CH 18-DIMMABLE 2(10A)
CH 19-DIMMABLE 3(10A)
CH 20-DIMMABLE 4(5A)
CH 21-DIMMABLE 5(5A)
CH 25-MOMENTARY 1 (10A)
CH 26-MOMENTARY 2 (10A)
CH 27-MOMENTARY 3 (10A)