Garmin echoMAP 50s Guide Reference - Page 40

Browse online or download pdf Reference for Marine Equipment Garmin echoMAP 50s Guide. Garmin echoMAP 50s Guide 42 pages. Technical reference for garmin nmea 2000 products
Also for Garmin echoMAP 50s Guide: Installation Instructions Manual (12 pages), Reference Manual (2 pages), User Manual (28 pages), Product Information (37 pages), Instructions Manual (28 pages), Template (2 pages), Declaration Of Conformity (6 pages), Configuration Manual (2 pages), Quick Start Manual (4 pages), Installation Instructions Manual (8 pages), Owner's Manual (38 pages)

Print Page

NMEA 2000 Checklist

Intelliducer (Intelligent Depth Transducer–Transom Mount and Thru-Hull)

Setting the Keel Offset

Adjust the Keel offset to display a depth reading from the water line or from the lowest point of the boat (keel) rather than the actual location

of the Intelliducer.

To adjust the keel offset:

1. While viewing the NMEA 2000 device configuration menu, select a specific Intelliducer and select

2. Enter the measured distance from the Intelliducer location to the water line or to the keel of the boat.

• If you are measuring down to the keel (Intelliducer installed at the water line), enter a (+) positive number.

• If you are measuring up to the water line (Intelliducer installed on the keel), enter a (-) negative number.

GWS 10 (Garmin Wind Sensor)

Configuring the Wind Angle Offset (Orientation)

When mounting the sensor, you must adjust the angle offset if you did not orient the GWS 10 as described in the GWS 10 Installation

Instructions.

To configure the wind angle offset (orientation):

1. While viewing the NMEA 2000 device information, select

2. Select the angle in degrees to adjust for the difference in orientation.

tiP: The angles are configured clockwise around the mast of the boat. For example, 90 degrees is on the starboard side of the boat, and 270 degrees is

on the port side.

Configuring the Wind Speed Filter

The wind speed filter governs how quickly the NMEA 2000-compatible display device shows a change in the wind speed. A lower filter setting

shows changes in the wind speed more gradually, and may stabilize the display.

To configure the wind speed filter:

1. While viewing the NMEA 2000 device information, select

2. Choose from the following options to adjust the filter settings.

• Off—the wind speed data is not filtered.

• On—select a lower number to show a change in the wind speed more gradually, and help the gauge needle or wind speed number to

move or change more steadily.

• Auto—automatically adjusts the filter settings based on wind conditions.

Intelliducer at the water line

Enter a (+) positive number

to show depth at the

bottom of the keel.

Intelliducer at the bottom

of the keel

Enter a (-) negative

number to show depth at

the surface.

Config

Keel Offset

Wind Angle

Offset.

Wind Speed

Filter.

Config

Keel

Offset.

Technical Reference for Garmin NMEA 2000 Products