Garmin FUSION XS Series Installation Instructions Manual - Page 6
Browse online or download pdf Installation Instructions Manual for Marine Equipment Garmin FUSION XS Series. Garmin FUSION XS Series 13 pages. Marine wake tower speakers
Also for Garmin FUSION XS Series: Installation Instructions Manual (11 pages), Installation Instructions Manual (6 pages), Installation Instructions (4 pages), Installation Instructions Manual (6 pages)
Print Page
Connecting the LED Wires to Power
NOTE: This feature is available on only the sports model.
You must connect all 12 Vdc wiring to the LEDs to a 3 A fuse at the power-source end of the cable. You should
connect the positive (+) power wire to a 12 Vdc power source through an isolator switch or circuit breaker to
turn the LEDs on and off. You can use the same isolator or circuit breaker controlling the power supply to your
stereo, which allows you to turn the LEDs and the stereo on and off at the same time.
You should use 20 AWG (0.5 through .75 mm
1 Route the positive power (+) and negative ground (-) wires from the LED-wire connections to the battery.
2 Connect the negative wire to the negative (-) battery terminal.
3 Connect the positive wire to the positive (+) terminal through a 3 A fuse and isolator switch or circuit breaker.
Subwoofer Sound Optimization
While installing the subwoofer, you can ensure the sound from the subwoofer is optimized by running the
subwoofer out of phase. You can switch the positive and negative wires on the amplifier or source to run them
out of phase.
Running the subwoofer out of phase from the speakers allows you to hear if the perception of bass is more
from the location of the subwoofer or from the speakers. If running the subwoofer out of phase gives a better
perception that the bass is from the speakers' location, then out-of-phase wiring is correct for your system.
You can run the subwoofer out of phase by temporarily switching the positive and negative connections from
the subwoofer at the amplifier or source. Depending on the outcome of the test, you can then switch the
connections back if necessary.
Configuring the Subwoofer for 2.1 Operation
The subwoofer features dual 2 Ohm voice coils and is pre-configured for 4 Ohm operation. You can change the
configuration of the subwoofer for 2.1 operation (two speakers and one subwoofer) when connected to a
FUSION stereo with DSP capability, such as an Apollo
1 Disconnect the gray wire and the white with a black stripe wire from the jumper terminals on the back of the
subwoofer.
2 Connect the wires from the subwoofer to the stereo using the following table as a reference.
Subwoofer wire
White
White with a black stripe
Gray
Gray with a black stripe
3 Turn on the connected stereo.
4 Launch the FUSION-Link
The subwoofer operates in 2.1 mode, with the volume control tied to zone 1 on the stereo. The zone 2 volume
control and the zone 2 line out connectors are disabled.
Additional Information
True-Marine
Products
™
True-Marine products are subjected to rigorous environmental testing under harsh marine conditions to surpass
industry guidelines for marine products.
Any product that bears the True-Marine stamp of assurance has been designed for simplicity of use and
combines advanced marine technologies to deliver an industry leading entertainment experience. All True-
Marine products are supported by the FUSION 3-year worldwide limited consumer warranty.
6
2
) or thicker wire to connect the LEDs to the battery.
™
app, and select the 2.1 option for the connected stereo.
RA770.
™
Stereo wire
Zone 2 right positive (+)
Zone 2 right negative (-)
Zone 2 left positive (+)
Zone 2 left negative (-)
XS Series Subwoofer Installation Instructions