Garmin GHP 10V Installation Instructions Manual - Page 7
Browse online or download pdf Installation Instructions Manual for Marine Equipment Garmin GHP 10V. Garmin GHP 10V 20 pages. Marine autopilot system
Also for Garmin GHP 10V: Installation Instructions Manual (48 pages), Owner's Manual (28 pages), Installation Instructions Manual (20 pages)
Print Page
Wiring the CCU
Route the connector-terminated end of the CCU cable to the location where you plan to access the Volvo multilink bus, and install a NMEA
2000 drop cable extension (not included) if necessary. Connect the cable to the Autopilot Gateway after you have installed the
gateway
(page
7).
Route the bare-wire end of the CCU cable to the location best suited to wire it to power, to the alarm buzzer, and to the GHC 10. Wire the CCU
to the alarm buzzer and to the GHC 10 after you have installed the alarm buzzer and the GHC 10 (see
To wire the CCU to power:
1. On the bare-wire end of the CCU cable, isolate the red (+) and black (-) wires.
2. Connect the red (+ or positive) and black (- or ground) wires to power and ground through the ignition switch or through an external switch.
If the red (+) and black (-) wires are not long enough, extend the appropriate wires with 22 AWG wire.
3. Solder and cover all bare-wire connections.
Installing the Autopilot Gateway
The Autopilot Gateway allows the GHP 10V Autopilot System to communicate with the Volvo EVC system and steer the boat.
Mounting the Autopilot Gateway
Mount the Autopilot Gateway near the location where you plan to access the Volvo proprietary multilink
bus, and ensure that the Volvo interface cable reaches the location where you plan to access the Volvo
multilink bus. Secure the Autopilot Gateway with cable ties or other appropriate mounting hardware (not
included).
Connecting the Autopilot Gateway
1. Open the Volvo multilink bus and disconnect the multilink breakout cable.
2. Connect the proprietary Volvo connector (
included Y-cable.
3. Close the Volvo multilink bus.
4. Connect the CCU interface connector (
Caution: Do not connect the CCU interface connector on either the CCU cable or the Autopilot Gateway to a NMEA 2000 network.
Installing the Alarm Buzzer
The alarm buzzer audibly alerts you to important GHP 10V events.
Mounting the Alarm Buzzer
Mount the alarm buzzer near the helm station. You can mount the alarm buzzer under the dashboard if you prefer. Secure the alarm buzzer with
cable ties or other appropriate mounting hardware (not included).
Wiring the Alarm Buzzer
1. Route the alarm-buzzer cable to the bare-wire end of the CCU cable. If the cable is not long enough, extend the appropriate wires with 28
AWG wire.
2. Use the table below to make the appropriate connections.
3. Solder and cover all bare-wire connections.
GHP 10V Installation Instructions
➊
) from the Autopilot Gateway to the multilink bus using the
) to the CCU cable.
➋
Alarm Buzzer Wire Color
White (+)
Black (-)
Alarm Buzzer Wiring Table
pages 7 and
CCU cable Wire Color
Orange (+)
Blue (-)
8).
➊
➊
➋
➋
Autopilot Gateway Connectors
Autopilot Gateway Connectors