AEG F99705IM0P User Manual - Page 23
Browse online or download pdf User Manual for Dishwasher AEG F99705IM0P. AEG F99705IM0P 28 pages.
Print Page
14.1 Adjusting the level of the
appliance
A correct adjustment of the level of the
appliance allows the door to close and
seal correctly.
If the door does not close correctly,
loosen or tighten the adjustable feet to
level the appliance.
14.2 Water connection
Water inlet hose
Connect the inlet hose to a water tap
with an external BSP thread spout of
3/4''.
For best washing performance it is
recommended to connect the appliance
to a cold water supply.
Energy savings can be made by
connecting the appliance to a Solar
water system and using economy
options, however the water temperature
must not exceed 60° C.
Inlet water supply
• Water pressure: 800 kPa max - 50 kPa
min.
• Water flow rate 10 L / minute min.
• If water pressure is in excess of 800
kPa, a pressure reducing valve should
be used. Check for leaks.
• If water temperature is in excess of
60° C, a tempering valve should be
used. Check for leaks.
CAUTION!
Always use new hoses when
you connect the appliance
to the water mains. Old
hoses must not be used. The
water inlet hose must be
examined at an interval of
twelve months for
deterioration and replaced if
necessary.
The water pressure must be in the limits
indicated in the chapter ''TECHNICAL
INFORMATION''. Make sure that the
local water authority gives you the
average mains pressure in your area.
In order to pass the safety valve through
the kitchen cabinets, an opening of at
least 45 mm x 90 mm is needed.
Water drain hose
The highest point of the drain hose must
be no more than 600 mm from the floor
and must have a continuous fall to the
plumbing connection.
The drain hose can be lengthened using
additional lengths and connectors. These
must be purchased from Electrolux Spare
Parts. The extension length must not
exceed 2 metres.
The drain hose must be free of
obstructions.
Remove the sink plug when the
appliance drains the water to prevent
that the water goes back into the
appliance.
The appliance has a security feature to
prevent dirty water going back into the
appliance. If the spigot of the sink has a
non-return valve, this valve can cause the
appliance to drain incorrectly. remove
the non-return valve.
If you connect the water drain hose to a
trap spigot under the sink, remove the
plastic membrane. If you do not remove
the membrane, remaining food can
cause a blockage in the drain hose
spigot.
ENGLISH
23