AEG FAVORIT 34032 User Manual - Page 21

Browse online or download pdf User Manual for Dishwasher AEG FAVORIT 34032. AEG FAVORIT 34032 24 pages. Aeg dishwasher favorit 34032

Print Page

Malfunction

After the check, switch on the appliance. The programme continues from the point of inter-

ruption.

If the malfunction shows again, contact the service centre.

For other fault codes, not showed in the chart, contact the service centre.

The necessary data for the service centre is on the rating plate.

We recommend that you write the data here:

Model (MOD.)

Product number (PNC)

Serial number (S.N.)

The washing results and drying results are not satisfactory

Problem

The dishes are not clean.

Limescale particles on the

dishes.

Fault code

The mains plug is not

connected in.

Blow out fuse in the

household fuse box.

The delay start is set.

Possible cause

The selected washing pro-

gramme was not applicable for

the type of load and soil.

The baskets were not loaded

correctly, water did not touch

all surfaces.

The spray arms could not turn

freely because of incorrect ar-

rangement of the load.

The filters are dirty or not as-

sembled and installed correctly.

The quantity of detergent was

not sufficient or missing.

The salt container is empty.

Incorrect water softener ad-

justment

The salt container cap is not

closed correctly.

What to do if...

Possible cause

Put in the mains plug.

Replace the fuse.

If you want to cancel

the delay start, refer to

'Select and start a

washing programme'.

....................

Possible solution

Make sure that the washing

programme is applicable for

the type of load and soil.

Load the baskets correctly.

Make sure that an incorrect ar-

rangement of the load does not

cause a blockage of the spray

arms.

Make sure that the filters are

clean and correctly assembled

and installed.

Make sure that the quantity of

detergent is sufficient.

Fill the salt container with dish-

washer salt.

Adjust the water softener.

Make sure that the salt con-

tainer cap is closed correctly.

Possible solution