Garmin STRIKER PLUS 5 Installation Instructions Manual - Page 2
Browse online or download pdf Installation Instructions Manual for Marine Equipment Garmin STRIKER PLUS 5. Garmin STRIKER PLUS 5 16 pages. Compass safe distance
Also for Garmin STRIKER PLUS 5: Owner's Manual (16 pages), Quick Start Manual (2 pages)
Ice Fishing Kit Installation Instructions
Getting Started
Battery Information
Battery Warnings
The fishfinder device uses a user-replaceable, sealed, lead-acid battery. If
these guidelines are not followed, the battery may experience a shortened life
span or may present a risk of damage to the device, fire, chemical burn,
electrolyte leak, and/or bodily injury.
may cause sparks,
flames,
or
heat.
• Do not incinerate the
battery.
• Keep the battery tightly closed.
• Do not use a sharp object to remove the battery.
• Do not disassemble, puncture, or damage the battery.
• Do not swallow, touch, or inhale the contents of an open battery. Avoid
contact with internal acid. Contact with internal acid may cause irritation or
severe burns. Irritation may occur to the eyes, respiratory system, and
skin.
Flush with water at once if contact is made with acid.
• Do not submerge the battery and avoid contact with water.
• Do not short the battery terminals.
• Do not drop or throw the battery.
•
Keep the battery away from
children.
• Only replace the battery with the correct replacement battery. Using
another battery presents a risk of fire or explosion of the device or charger.
• Only charge the battery with the included
charger.
• Do not charge the battery in an unventilated area.
• Store in a cool, dry, and well-ventilated
area.
• Do not charge the battery in a gas-tight container.
• Do not leave the device exposed to a heat source or in a high-temperature
location, such as in the sun in an unattended
vehicle.
To prevent
damage,
remove the device from the vehicle or store it out of direct sunlight.
• Do not use organic solvents or other cleaners other than recommended
chemical cleaners on the battery.
• Contact your local waste disposal department to dispose of the battery in
accordance with applicable local laws and regulations.
• When storing the battery for an extended time, store within the following
temperature range: from
5o
F to 104°F (from
-15°
C to
40°
C).
• Do not operate the battery outside of the following temperature
range:
from
so
F to 122° F (from
-15°
C to
50°
C).
Charging the Battery
Ensure that you connect the correct connector to the correct battery terminal.
Damage to the battery, device, or bodily harm may occur if the device is
~E~op:.~~~~~~~~.?-
~
~~!~-~~~~ery:
. _
-
---·-- _____
.
.
.
..
.
·-···
. ··----·-· _ ········
Before you can charge the battery using the charger, you must disconnect the
device power cable from the positive and negative terminals on the battery.
The battery is rechargeable and can be charged by connecting the battery to a
wall charger.
1
Connect the positive connector on the wall charger onto the positive
terminal on the battery.
2
Slide
the negative connector on the wall charger onto
the
negative terminal
on the battery.
3
Connect the wall charger to the wall outlet.
Battery Tips
• The life expectancy of a sealed lead acid battery can be extended by
recharging often and not completely discharging the
battery.
2
• Sealed lead acid batteries slowly lose their charge while in storage. For
best
results,
charge the battery prior to use.
• When used in cold temperatures, sealed lead acid batteries do not hold the
charge as long as in warmer temperatures.
• To avoid spilling the internal
acid,
keep the battery in the upright position.
• Sealed lead acid batteries are completely recyclable.
Specifications
Battery type
Sealed, lead acid
Battery life
About11 hr.
NOTE: The actual battery life of a fully charged battery
can vary based on the temperature the battery is
operated and stored in, the age of the battery, and the
depth of the water.
Battery shelf life after
1 month:
92%
charging
3
months:
90%
6
months:
80%
Battery operating temperature From
5o
to 122oF (from -15° to 50oC)
range
Battery charging temperature From
5o
to 104oF (from -15° to 40°C)
range
Battery storage temperature
From
5°
to 104°F (from
-15°
to 40°C}
range
Physical size (assembled kit
L
x
W
x
H: 10.629 in.
x
10.629 in.
x
11.02 in. (270 mm
with device)
x
270 mm
x
280 mm)
Weight (unassembled kit with 8.498 lb. (3855 g)
device)
Assembling the Mount
You need a Phillips screwdriver to assemble the mount.
1
Insert the handle
CD
into the two openings on the portable mount®.
2
Attach the handle to the portable mount using two M4•0.7•40 mm screws
@
and M4x7 nuts @).
3 Press the M6x 1 nut
@
into the bottom of the swivel-mount base
®
.
4
Place the swivel-mount base on the portable mount, route the device
power and transducer cables through the pass-through holes
(J),
and
fasten the swivel-mount base using the three M4x0.7x10 mm screws @.
5
Place the bail-mount bracket on the swivel-mount base.
i
I
!
Installation Instructions